INSTALLATION | ||
|
|
|
CONNECTION OF AN LN-23P WIRE FEEDER TO THE COMMANDER 500
•Shut the welder off.
•Connect the
•Set the “WIRE FEEDER VOLTMETER” switch to
•Set the “SELECTOR” switch to
•Set the “WELDING TERMINALS” switch to
“REMOTELY CONTROLLED”.
•Set the ARC CONTROL to desired crispness. SOFT for MIG - CRISP for Innershield.
•Set the “IDLE” switch to the “HIGH” position. If you are using an
CONNECTION OF AN
For connection diagrams and instructions for connect- ing an
CONNECTION OF AN
•Shut the welder off.
•Connect the
•Set the “WIRE FEEDER VOLTMETER” switch to either “+” or
•Set the “SELECTOR” switch to the
•Adjust the “ARC CONTROL” knob to desired Crispness. SOFT for MIG and CRISP for Innershield.
•Set the “WELDING TERMINALS” switch to the “REMOTELY CONTROLLED” position.
•Set the “IDLE” switch to the “AUTO” position. When not welding, the Commander 500 engine will be at the low idle speed.
COMMANDER 500