A-7

INSTALLATION

A-7

 

 

 

If 480 volt single phase load is to be run, the X lead must be one of the leads in the circuit in order for the automatic idle to function. Using a NEMA plug L16-20P, connect either X and Y or X and Z to the receptacle, as well as the machine ground.

All auxiliary power is protected by circuit breakers with the fol- lowing values:

Y

480 V

X

Z

GND

(FOR ALL SINGLE AND THREE PHASE LOADS)

The 120V has 20 amp circuit breakers for each duplex recepta- cle. The 240V has 50 amp circuit breakers for each hot lead going the 240V receptacle.

The 480V 3 phase circuit breakers / switch has a 3 phase, 15 amp circuit breaker.

Ground Wire

Periodically check the ground wire at plugs, power cords and auxiliary loads to ensure that the grounding circuit is intact and connected.

MOTOR STARTING

Most 1.5 hp AC single phase motors can be started if there is no load on the motor or other load connected to the machine, since the full load current rating of a 1.5 hp motor is approxi- mately 20 amperes (10 amperes for 240 volt motors). The motor may be run at full load when plugged into only one side of the duplex receptacle. Larger motors through 2 hp can be run provided the receptacle rating as previously stated is not exceeded. This may necessitate 240V operation only.

The 480 volt 3 phase output of the RANGER 3 PHASE is capa- ble of running most 480VAC 3 phase motors up to 10HP. A 10HP motor must be started with no load on the motor and no other load connected to the machine, since the full load current of a 10HP 480VAC 3 phase motor is approximately 12.5 amps. Refer to the reconnect phase output to any load, the ground at the 3 phase receptacle is NOT the neutral of 3 phase connec- tion, and should under no circumstance be connected to the neutral of any 3 phase load.

TABLE lll

ELECTRICAL DEVICE USE WITH THE RANGER® 3 PHASE.

 

Type

Common Electrical Devices

Possible Concerns

 

 

 

 

 

Resistive

Heaters, toasters, incandescent

NONE

 

 

light bulbs, electric range, hot

 

 

 

pan, skillet, coffee maker.

 

 

 

 

 

 

Capacitive

TV sets, radios, microwaves,

Voltage spikes or high voltage

 

 

appliances with electrical control.

regulation can cause the capacitative

 

 

 

elements to fail. Surge protection,

 

 

 

transient protection, and additional

 

 

 

loading is recommended for 100%

 

 

 

fail-safe operation. DO NOT RUN

 

 

 

THESE DEVICES WITHOUT ADDI-

 

 

 

TIONAL RESISTIVE TYPE LOADS.

 

 

 

 

 

Inductive

Single-phase induction motors,

These devices require large

 

 

drills, well pumps, grinders, small

current inrush for starting.

 

 

refrigerators, weed and hedge

Some synchronous motors may

 

 

trimmers

be frequency sensitive to attain maxi-

 

 

 

mum output torque, but they SHOULD

 

 

 

BE SAFE from any frequency induced

 

 

 

failures.

 

 

 

 

 

Capacitive/Inductive

Computers, high resolution TV sets,

An inductive type line condition-

 

 

complicated electrical equipment.

er along with transient and surge pro-

 

 

 

tection is required, and liabilities still

 

 

 

exist. DO NOT USE THESE

 

 

 

DEVICES WITH A RANGER® 3

 

 

 

PHASE

The Lincoln Electric Company is not responsible for any damage to electrical components improperly connected to the RANGER® 3 PHASE.

RANGER® 3 PhASE

Page 14
Image 14
Lincoln Electric IM10030 manual Ground Wire, Motor Starting, Type Common Electrical Devices Possible Concerns