MAINTENANCE | ||
|
|
|
ENGINE ADJUSTMENTS
OVERSPEED IS hAzARDOUS
WARNING
WARNING
GASES FROM bATTERY can explode.
• Keep sparks, flame and cigarettes away from battery.
To prevent EXPLOSION when:
•INSTALLING A NEW bATTERY - disconnect negative cable from old battery first and connect to new bat- tery last.
The maximum allowable high idle speed for this machine is 3750 RPM, no load. Do NOT tamper with governor components or setting or make any other adjustments to increase the maximum speed. Severe personal injury and damage to the machine can result if operated at speeds above maximum.
Adjustments to the engine are to be made only by a Lincoln Service Center or an authorized Field Service Shop.
SLIP RINGS | bATTERY |
|
•CONNECTING A bATTERY ChARGER - Remove bat- tery from welder by disconnecting negative cable first, then positive cable and battery clamp. When reinstalling, connect negative cable last. Keep well ventilated.
•USING A bOOSTER - connect positive lead to battery first then connect negative lead to engine foot.
bATTERY ACID CAN bURN EYES AND SKIN.
•Wear gloves and eye protection and be careful when working near battery. Follow instructions printed on battery.
A slight amount of darkening and wear of the slip rings | 1. When replacing, jumping, or otherwise connecting | ||||
the battery to the battery cables, the proper polarity | |||||
and brushes is normal. Brushes should be inspected | |||||
must be observed. Failure to observe the proper | |||||
when a general overhaul is necessary. If brushes are | |||||
polarity could result in damage to the charging cir- | |||||
to be replaced, clean slip rings with a fine emery | |||||
cuit. The positive (+) battery cable has a red termi- | |||||
paper. | |||||
nal cover. | |||||
|
|
| |||
CAUTION | 2. If the battery requires charging from an external | ||||
charger, disconnect the negative battery cable first | |||||
|
|
| |||
Do not attempt to polish slip rings while engine is | and then the positive battery cable before attaching | ||||
the charger leads. Failure to do so can result in | |||||
running. | |||||
damage to the internal charger components. When | |||||
reconnecting the cables, connect the positive cable | |||||
|
|
| |||
|
|
| first and the negative cable last. | ||
|
|
| hARDWARE | ||
|
|
| Both English and Metric fasteners are used in this | ||
|
|
| welder. | ||
| ENGINE MAINTENANCE PARTS | ||||
|
|
|
|
| |
|
|
| KOhLER C23S |
| |
|
|
|
|
| |
|
|
| KOHLER 12 050 01 |
| |
| Oil Filter |
| FRAM PH8172* |
| |
|
|
|
|
| |
| Air Filter |
| KOHLER 47 083 03 |
| |
| Element |
| FRAM CA79 |
| |
|
|
|
|
| |
| Air Filter |
| KOHLER 24 083 02 |
| |
|
|
|
| ||
|
|
|
|
| |
| Fuel Filter |
| KOHLER 24 050 10 |
| |
|
|
|
|
| |
| Spark Plugs |
| CHAMPION RC12YC |
| |
| (Resistor |
| (.030” GAP) |
| |
| Type) |
|
|
| |
|
|
|
|
| |
* Oil capacity increases from 2.0 Qts. to 2.1 Qts. when using this filter.
RANGER® 3 PhASE
