Lincoln Electric IM607 manual Optional Accessories

11 ACCESSORIES 11

OPTIONAL ACCESSORIES

K964-1 Undercarriage with Pivoting Single Gas Cylinder Platform - This undercarriage features a piv- oting platform to easily load and unload the gas cylin- der without lifting. It was designed specifically for the Square Wave TIG 175 power source, and accommo- dates 7” to 9 1/4” diameter gas cylinders. The under- carriage comes completely assembled and mounts directly to the power source.

K870 Foot Amptrol™ - A foot operated remote current control to be used while welding in 2 Step TIG mode. In 4 Step TIG mode the Foot Amptrol acts as an Arc Start Switch.

K812 Hand Amptrol™ - A thumb operated remote current control to be used while welding in 2 Step TIG mode. In 4 Step TIG mode the Hand Amptrol acts as an Arc Start Switch.

K814 Arc Start Switch - The Arc Start Switch does not provide remote current control. In 2 Step TIG mode the Arc Start Switch allows on/off welding at the current set with the Current Control on the control panel. The Start/Crater Current and Downslope Time controls are only active in 4 Step mode.

Magnum® LA-9 and LA-17 TIG Torches - The follow- ing standard Magnum® TIG torches with one-piece cable may be used with the Square Wave TIG 175.

• K859-1	LA-9	12.5 ft	medium back cap
• K859-5	LA-9	25 ft	medium back cap
• K860-1	LA-17	12.5 ft	long back cap
• K860-5	LA-17	25 ft	long back cap

NOTE: Each torch requires a Twistmate plug (S22529-

1)and strain relief boot (M17255) be installed onto the cable. Collets, collet bodies, and nozzles are not included and must be ordered separately.

Twistmate® Plug (S22529-1) and Strain Relief Boot (M17255) - One of each is shipped with the welder to connect any TIG torch with a right hand male 3/8- 24UNF-2B fitting. The Magnum LA-9 and LA-17 Torches are recommended. If you do not care to inter- change these parts when using more than one torch you may order additional sets. The Twistmate plug pro- vides connection for both gas and welding current.

Tungstens, Collets, Collet Holders, Gas Cups, Backcaps and Other Torch Parts - Standard Magnum® parts and accessories for this torch may be used when using a Magnum LA-9 or LA-17.

TIG Torch Parts Kits - Parts kits are available for the LA-9 and LA-17 TIG torches. These kits include back cap, collets, collet bodies, nozzles and tungstens.

Order KP507 for LA-9 torches Order KP508 for LA-17 torches

See publication E12.150 for parts kits breakdown.

Cut Length Consumables - TIG welding filler metals are available for welding stainless steel, mild steel, alu- minum and copper alloys. See publication C9.10.

SQUARE WAVE TIG 175