Lincoln Electric IM610-A manual Optional Accessories

C-1 ACCESSORIES C-1

OPTIONAL ACCESSORIES

1.K520 Utility Cart — Designed to transport the Lincoln family of small welders. Has provisions for mounting a single gas cylinder. Has front casters and large rear wheels. Handle height is easily adjustable. Bottom tray provided for tools and accessories. Easy assembly required; takes less than 15 minutes.

2.K1800-1 CO2 Adjustable Regulator and Hose Kit — Includes an adjustable pressure flow regulator for

use on CO2 cylinders.

Weld shielding gas may be obtained from a weld- ing supply distributor.

Also included is a gas hose which connects to the rear of the welder.

See “Gas Connection” in Installation section for installation instructions.

3.K1799-1 Argon-Mixed Gas Adjustable Regulator and Hose Kit (1)

Includes an adjustable pressure and flow regulator for use on argon-mixed gas cylinders. Also includ- ed is a gas hose which connects to the rear of the welder.

4. K586-1 Deluxe Adjustable Gas Regulator &

Hose Kit

Accommodates CO2 or mixed Gas Cylinders.

5.K663-2 Aluminum Welding Kit — This kit required for welding with .035” aluminum wire. Included with this kit are a drive roll and idle roll assembly, liner and guide tubes and a contact tip.

It is important when changing between welding with steel wire and aluminum to exchange these components due to the lubricant applied to steel wire. Failure to do so may result in con- taminated welds when welding aluminum.

See Maintenance section for instructions on installing drive roll, cable liner, contact tip and their proper con- figuration.

6.K695-2 Spot / Stitch Timer Kit — Includes spot timer to control the spot welding arc time, and a stitch timer to control the on/off cycle time of the arc to prevent burnthrough on thin gauge metals. Also includes spot welding nozzle.

The Spot/Stitch Timer Kit installs inside the wire feed compartment, replacing the blank panel locat- ed below the gun trigger lead connectors, per the installation instructions included with the kit.

7.K549-1 .035 (0.9 mm) Innershield Welding Kit Includes a contact tip, a gasless nozzle and a cable liner to permit the Magnum™ 100L gun and cable to use .035” (0.9 mm) diameter flux-cored electrode. Also included is a spool of .035 (0.9 mm) Innershield NR-211-MP.

SP-175 PLUS