Controls and Settings, Run | Lincoln Electric IM805 guide

B-2

OPERATION

B-2

CONTROLS AND SETTINGS

All welder and engine controls are located on the case front panel. Refer to Figure B.1 and the explanations that follow.

Figure B.1 Case Front Panel Controls

4

5

6

3

11

14

13

1

2

15

16

17

ENGINE CONTROLS (Items 1 through 8)

1. RUN

STOP

SWITCH

Toggling the switch to the RUN position energizes the fuel solenoid for approximately 30 seconds. The engine must be started within that time or the fuel solenoid will deenergize, and the switch must be toggled to reset the timer.

2. START PUSHBUTTON

Energizes the starter motor to crank the engine. With the engine "Run / Stop" switch in the "Run" position, push and hold the Start button to crank the engine; release as the engine starts. Do not press while engine is running since this can cause damage to the ring gear and/or starter motor.

7

8

9

10

12

19

20

18

21

3. HOUR METER

The hour meter displays the total time that the engine has been running. This meter is a useful indicator for scheduling preventive maintenance.

4. FUEL LEVEL GAUGE

Displays the level of diesel fuel in the fuel tank.

The operator must watch the fuel level closely to prevent running out of fuel and possibly having to bleed the system.

5. ENGINE TEMPERATURE GAUGE

The gauge displays the engine oil temperature.

Vantage 500 DEUTZ

Image 19

Lincoln Electric IM805 manual Controls and Settings, Run

Contents

Vantage 500 Deutz California Proposition 65 Warnings Safety Electric Shock can kill Welding Sparks can cause fire or explosion Sûreté Pour Soudage a L’Arc Précautions DE Sûreté Thank You Table of Contents Vii Installation Safety Precautions InstallationLocation / Ventilation Towing High Temperature OperationLifting High Altitude Operation Engine Cooling System PRE-OPERATION Engine ServiceEngine BREAK-IN Welding Terminals 5INSTALLATIONA-5 Output Remote ControlAuxiliary Power Receptacles Standby Power Connections Figure A.2 Connection of the Vantage to Premises Wiring Connection of LN-15 to the Vantage Connection of Lincoln Electric Wire FeedersConnection of AN LN-23P Wire Feeder to the Vantage Connection of LN-7, LN-8 or LN-742 to the Vantage Vantage 500 Deutz Connection of the LN-25 to the Vantage Operation Safety InstructionsGeneral Description RUN Controls and Settings Welding Controls Items 9 through Stopping the Engine Auxiliary Power ControlsEngine Operation Starting the Engine Welder Operation For Tungsten Electrodes Operation Auxiliary Power Operation Operation Optional Field Installed Accessories Accessories Routine and Periodic Maintenance MaintenanceEngine Maintenance Secondary Fuel Filter Fuel PRE-FILTER/WATER Separator AssemblyFuel Filters Water Separator Element Cooling System Cooling Blower Belt Battery Handling Welder / Generator Maintenance HOW to USE Troubleshooting Guide Troubleshooting Possible Areas Misadjustments Course of Action Function Problems 500 Connection Diagram DIAGRAMSF-2 Diagram Commander / K867 / K775 / LN-7 Connection Diagram Diagrams Diagrams Commander / K867 / LN-8 Connection Diagram Diagrams Diagrams Engine Welders /LN-8 Connection Diagram Diagrams Diagrams Diagrams Diagrams Dimension Print Vantage 500 Deutz Inflammable Votre corps Avec des pièces sous tension Insulate yourself from workGround Mojada Débranchez le courant avant Utilisez un ventilateur ou un Keep your head out of fumes Turn power off before servicingGuards off Humos. Utilice ventilación o Servicio Aspiración para gases