Contents
Main
Contents
Preface
Barracuda 4LP Product Manual
Electrostatic discharge protection
Important safety information and precautions
Page
Wichtige Sicherheitshinweise
Page
Page
European Union Compliance
Technical support services
SeaFONE at 1-800-SEAGATE (1-800-732-4283)
Seagate Technology online services
SeaNET
SeaBOARD
Seagate CompuServe Forum
go seagate
Seagate Technology FAX services SeaFAX
Seagate technical support FAX
Seagate technical support
xxxx
SeaTDD 408-944-9121
General description
Barracuda 4LP Product Manual
*
Page
Page
Barracuda 4LP Product Manual
Barracuda 4LP Prod- uct Manual.
Initial setup information
Drive models Page
General information
SCSI ID jumpers
Drive termination
I/O circuits and data path widths
Page
Page
Barracuda 4LP Installation Guide, Rev. B 23
Figure 3c. Multiple drive connection to host adapter
24 Barracuda 4LP Installation Guide, Rev. B
Figure 3d. Multiple-drive connection to host adapter
Page
Providing adequate cooling
Khlung des Systems
28 Barracuda 4LP Installation Guide, Rev. B
Figure 4. Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf
Mounting the drive and connecting cables
Installation des Laufwerkes und Anschlu der Kabel
Page
Page
Hinweis:
Page
34 Barracuda 4LP Installation Guide, Rev. B
[4]
FDE
P
M
Formatting the drive
Zero, None,
No hard drive installed
36 Barracuda 4LP Installation Guide, Rev. B
N/ND drives sectionSetting the SCSI ID jumpers
Figure 7. Setting the SCSI ID on model N drives
Barracuda 4LP Installation Guide, Rev. B 37
Terminating the drive
Disable SCSI terminator
Figure 8. Terminating the drive
Enable SCSI terminator (default)
38 Barracuda 4LP Installation Guide, Rev. B
N model drives
Term. Power from Drive (default)
Term. Power to SCSI Bus
Figure 9. Setting terminator power jumpers
Other applicable jumper options
Several other jumper options are available as illustrated.
Figure 10. Additional jumper options
40 Barracuda 4LP Installation Guide, Rev. B
W/WD drives sectionSetting the SCSI ID jumpers
Figure 11. Setting the SCSI ID on model W/WD drives
Jumper Plug (enlarged to show detail) J6
Drive Front Pin 1
Barracuda 4LP Installation Guide, Rev. B 41
Terminating the drive
Barracuda 4LP Installation Guide, Rev. B 43
WD model drives
Term. Power to SCSI Bus (default)
W model drives
Term. Power from Drive (default)
Other applicable jumper options
Other option jumpers are available as illustrated below.
Figure 15. Additional jumper options
Page
46 Barracuda 4LP Installation Guide, Rev. B
WC/DC drives Applicable jumper options
Option jumpers are available as illustrated below.
Figure 16. Jumper options
38 Barracuda 4LP Installation Guide, Rev. B