Seagate ST34371N/W/WC/WD/DC manual Other option jumpers are available as illustrated below

44 Barracuda 4LP Installation Guide, Rev. B

W/WD drives

Other applicable jumper options

Other option jumpers are available as illustrated below.

Drive with
HDA up, PCB
down, viewed							Pin 1
from front		HDA
											J6
		L	R
	Reserved E		E A	3	A	2	A	1	A	0
		D	S

Reserved
11
Remote
LED	CATH
12

Shipped with cover installed.

Do not remove.

Do not install jumpers on these four positions.

	J2	Pin 1
Reserved
Delay Motor Start option
(valid only if the Enable
Motor Start jumper is
not connected)
Disable the Delay Motor		(default)
Start option.
Motor start delay equal
to the SCSI ID multiplied
by 12 seconds. For
example, if the SCSI
ID = 2, the drive starts
in 24 seconds.
Motor Start option
Disable motor start

Drive Front J6

J2

DC Power

Connector

J1

J6

Jumper Type (enlarged to show detail)

Pin 1

End

Pin 1

(default). The drive	(default)
starts according to the
Delay Motor Start option.
Enable motor start. The
drive waits for the Start
Unit command from the
host before starting the
spindle motor.
Write Protect option
Write protect = Off	(default)
(enables writing.
Write protect = On
(disables writing).
Parity Check option
Enable parity check of	(default)
SCSI bus.

SCSI I/O

Connector J2 Jumper Type (enlarged to

show detail)

Disable parity check.

Figure 15. Additional jumper options