Lincoln Electric IM805 manual Figure A.2 Connection of the Vantage to Premises Wiring

A-7 INSTALLATION A-7

2.Take necessary steps to assure load is limited to the capacity of the Vantage by installing a 50 amp, 240 VAC double pole circuit breaker. Maximum rated load for each leg of the 240 VAC auxiliary is 50 amps. Loading above the rated output will reduce output voltage below the allowable -10% of rated voltage which may damage appliances or other motor-driven equipment and may result in overheating of the Vantage engine.

3.Install a 50 amp 120/240 VAC plug (NEMA Type 14-50) to the double-pole circuit breaker using No. 6, 4 conductor cable of the desired length. (The 50 amp, 120/240 VAC plug is available in the optional K802R plug kit.)

4.Plug this cable into the 50 Amp 120/240 Volt receptacle on the Vantage case front.

Figure A.2 Connection of the Vantage to Premises Wiring

240Volt

60 Hz.

3-Wire

Service

240 VOLT

POWER

120 VOLT

COMPANY

120 VOLT

METER

GROUNDED CONDUCTOR

NEUTRAL

BUS

N

DOUBLE POLE DOUBLE THROW					LOAD
SWITCH RATING TO BE THE SAME
AS OR GREATER THAN PREMISES
SERVICE OVERCURRENT
PROTECTION.
				PREMISES
				DISCONNECT AND
				SERVICE
			GROUND
		50AMP		OVERCURRENT
				PROTECTION
		240 VOLT
		DOUBLE
50 AMP, 120/240		POLE
		CIRCUIT
VOLT PLUG	240 VOLT
		BREAKER
NEMA TYPE 14-50

GND

	N
50 AMP, 120/240 VOLT		NOTE: No. 6 COPPER CONDUCTOR CABLE SEE
RECEPTACLE
	NATIONAL ELECTRICAL CODE FOR ALTERNATE WIRE
		SIZE RECOMMENDATIONS.

Vantage 500 DEUTZ