Lincoln Electric IM847-D manual Analog Miller Control Cable Adapter K2335-1, Pin Function

A-7 INSTALLATION A-7

ANALOG MILLER CONTROL CABLE

ADAPTER K2335-1

This Lincoln Electric wire feeder may be mounted to a limit- ed number of Miller Electric power sources. The Miller power source must have the amphenol pin definition shown in the table below for proper operation of the wire feeder.

Operation of Lincoln wire feeders on Miller power sources may result in lack of high speeds or reduce pull force on high wire feed speeds. Maximum wire feed speed for the LF-72 operating on a Miller power source is approximately 720ipm. Be sure the Miller power source provides 24 VAC to the wire feeder and has overcurrent protection of no more than 15 amps. The power source must not exceed 113VDC peak.

POWER SOURCE

I JKAB

HNLC

GFMED

WIRE FEEDER

BA KJI

CLN H

DEMFG

	MILLER POWER SOURCE		LINCOLN WIRE FEEDER
Pin	Function	Pin	Function
A	24 VAC to feeder	I	42 VAC feeder
		D	Welding Output Control
B	Welding Output Control	C	Welding Output Control
C	+10VDC to feeder for remote control	E	Remote Voltage Control ("+" supply, from
			power source)
D	Remote control common	G	Remote Voltage Control ("-" supply, from
			power source)
E	0-10VDC from feeder for remote control.	F	Remote Voltage Control (control signal from
			feeder or remote.)
F	Current feedback to feeder.	J	Reserved for future use.
	Scaled 0-10V. 1 V = 100 amps.
	Referenced to pin D.
G	24 VAC common.	K	42 VAC to feeder
H	Arc Voltage feedback to feeder.	L	Reserved for future use.
	Scaled 0-10V. 1 V = 10 Arc volts.
	Referenced to pin D.
I
J
K
L
M
N		N	Electrode voltage to power source (67)

Miller is a registered trademark not owned or licensed by The Lincoln Electric Company.

LF-72