OPERATION | ||
|
|
|
7a MENU BUTTON AND DISPLAY SWITCH – Pressing a d holding the (Menu) Button for about 5
TIG Mode Menu (with Advanced Control Panel installed):
seconds the menu display which allows:
enters
•Selection of up to seven programmable parameters (Preflow, Upslope, Hot Start, Arc Force, etc.) is dis- played on the digital meter by momentarily pressing and releasing the MENU button to step through the parameters.
•Setting of the desired level, displayed on the digital meter for the selected parameter, by pressing the DISPLAY (momentary) switch toggle to the right to increase the level setting, or to the left to decrease it.
DIGITAL DISPLAY |
Setting:
Selection 4:
0*
1
2
3
4
5
6
7
8
9
Selection 5:
0
1*
2
3
4
5
Description:
HS (TIG Hot Start % of output setting)
+0% (Only setting for SS0, above.)
+10%
+20%
+30%
+40%
+50%
+60%
+70%
+80%
+90%
UP (Upslope Time)
None | (Only setting for SS1 & SS2, above.) |
0.5sec.
1.0sec.
1.5sec.
2.0sec.
2.5sec.
| SET |
SELECT | |
DISPLAY | DISPLAY |
TIG Mode Menu
Setting: Description:
Selection 1: HF (High Freq.)
0Scratch start TIG (No
1* Normal
2Lift TIG (Touch start w/o
0No Preflow
10.1 sec.
2* 0.5 sec.
31.0 sec.
41.5 sec.
52.0 sec.
Selection 3: SS (MicroStart™ Start Pulse)
0 * No AC pulse/Low DC pulse (soft start)
1High AC/DC pulse (forceful start)
2HS setting (see below) for each pulse when Pulse
mode welding anodized aluminum.
*Default Factory Setting. (Indicated by "blinking" decimal point.)
Only selectable with Factory installed Advanced Control Panel.
*Default Factory Setting. (Indicated by "blinking" decimal point.)
STICK Mode Menu (with Advanced Control Panel installed ):
Setting: |
| Description: |
Selection 6: |
| HS (Stick Hot Start % added to output setting) |
0+0%
1+10%
2+20%
3+30%
4+40%
5 * |
| +50% |
6+60%
7+70%
8+80%
9+90%
Selection 7: AF (Stick Arc Force % added to output setting) | |||
0 | +0% | ("Softer" arc) | |
1 * |
| +10% |
|
2+20%
3+30%
4+40%
5+50%
6+60%
7+70%
8 | +80% |
| |
9 |
| +90% | ("Crisper" arc) |
*Default Factory Setting. (Indicated by "blinking" decimal point.)
Without Factory installed Advanced Control Panel the Stick menu displays “- -
•Any of the following actions will exit the menu display:
1.Pressing and holding the (Menu) Button again for about 5 seconds.
2.Allowing the menu display to be unchanged for about 15 seconds.
3.Closing the arc start switch (TIG Mode) or starting the arc (Stick Mode). Note: In Stick Mode the machine output will remain on while in menu display.
•
•All settings may be reset to the Factory Default Settings (above) by holding the (Menu) button pressed while turning on the machine’s Power switch. The display will show “rES” to indicate the defaults are reset.
