Lindy 2X8 manual Single Stage Installation, LED Lighting Pattern, Indication

English Manual 5

Installation

BEFORE YOU BEGIN

1.Make sure that power to all the devices you will be connecting up have been turned off. You must unplug the power cords of any computers that have the Keyboard Power On function. Otherwise, the switch will receive power from the computer.

2.To prevent damage to your equipment due to ground potential difference, make sure that all devices on the installation are properly grounded. Consult your dealer for technical details, if necessary.

Single Stage Installation

For an installation without cascading please use the following steps:

1.Connect the console cables to keyboard, mouse, monitor, speakers and microphone.

2.Connect the PCs with the appropriate PC ports of the CPU Switch. Use the appropriate LINDY systems cables as described before in chapter CABLES.

3.Connect the enclosed power supply to the mains and plug in its DC power cable to the CPU Switch.

4.Switch on the CPU Switch.

The Switch now undergoes a short Power-On-Self-Test. If there is a problem the LEDs will flash according to one of the following patterns:

LED Lighting Pattern

ONLINE LEDs 1-8 flash simultaneously

ONLINE LEDs 1-8 flash one after the other

ONLINE LEDs 1-8 pairs flash: 1+2, then 3+4, then 5+6, then 7 + 8, one after the other pair.

Indication

Internal RAM memory error

External RAM memory error

ROM Test error

If any of these occur turn off the switch and then turn on again. If this does not help please detach all cables from the rear side of the CPU Switch and turn off and switch on again. If the error still is present please contact the LINDY support hotline or your local dealer.

5.Complete all cable connections to the PCs that shall be connected.

6.Switch on all the PCs only after this procedure is complete.

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (DEC 2001)