Lindy 52022, 52020 manual Troubleshooting, Description/Action

English Short Manual

4. Troubleshooting

If you have trouble using the W-LAN 11 Wireless LAN Access Point, the starting point to troubleshoot any problems is by looking at the LED activity on the Access Point. The following “LED Error Table” is provided to assist you in diagnosing and solving operational problems.

PWR AP WLAN

LAN

LINK	Description/Action
Steady Normal operation where

Continuous

Green

Off

Continuous

Green

On

Off

Off

Flash

Green

Off

Off

Off

Flash

Green

Off

Off

Off

Green	flickering indicates interface
	activity.
-
	No action required.
	Normal operation that indicates
-	there is no LAN activity.
	No action required.
Off	Power failure.
	Check the power cord.
	Check the power supply.
	I valid loader firmware or the
Off	micro-controller is dead.
	Return the unit to the vendor
	for support.

Continuous

Green

Blink Green

Blink Green

Blink Green

-

Blink

Green

-

-

-

Blink

Green

-

-

-

Ivalid Access Point firmware. Upgrade the firmware via the utility or console mode.

Wireless LAN initialisation failure Check whether the wireless module has been properly installed.

nEthernet initialization failure Return the device to the vendor for support.

If you are still unable to solve the problem by checking the LED activity, the error may be caused by a configuration mismatch which prevents the W-LAN 11 from establishing a wireless connection with your network. You may check the following to ensure normal operation of the W-LAN 11.

WEP keys: If data encryption is activated, always remember to set WEP keys exactly the same on

nthe Access Point as are on the wireless stations.

Access Control: Make sure that the MAC address of your W-LAN 11 is not included in the Access Control table of other wireless devices.