Dynacord DPM 4000 manual Control Panel Of The DPC, 1Selection Keys and LED’s, 2ALL key and LED

DEVICE DESCRIPTIONS

5.2.3 Control Panel Of The DPC 4550

												11
1	2	3	4	5	6	7	8	9	10
													ALARM
11	12	13	14	15	16	17	18	19	20
													DPC 4550
21	22	23	24	25	26	27	28	29	30
31	32	33	34	35	36	37	38	39	40
									LÖSCHEN		EIN	STOPP	PROGRAMM
41	42	43	44	45	46	47	48	49	50		ESC		BUSY
									ALLE		GONG	TEXT	SPRECHEN
					1				2	3	4	5	6

figure 5.35 control panel of the DPC 4550

12

10

13

7

8

9

1Selection Keys and LED’s

Depending on the individual paging station model, 10, 20, 30, or 50 selection keys with corresponding LED’s are provided. The selection keys are used to pre-select areas or groups for the reproduction of messages, gong or alarm signals, vocal messages, or to assign programs (pressed once = ON, subsequently pressed = OFF). The LED’s indicate the momentary selection status (also refer to the paragraph “indications”). It is also possible to assign special functions or no function at all (no function assigned) to the selection keys. Assigning functions is performed during the configuration procedure via PC.

Note: When shipped, these keys are factory pre-set as area selection keys, where key 1 – area 1, key 2 – area 2, ..., key n – area n.

2ALL key and LED

The ALL key allows the selection of all programmed areas at once for transmitting messages, gong or alarm signals, vocal messages, or to assign programs. One time pressing selects all areas. The corresponding LED’s and the ALL LED are lit. Subsequent pressing cancels the selection.

3CANCEL key

This key offers different functions, depending on the actually selected operation mode, e.g. cancel calling pattern or cancel program-assignment. Which function is carried out at times is explained in detail in the paragraph OPERATION.

4GONG key (ESC) and LED

Pressing this key starts the transmission of a gong signal in the pre-selected areas or groups. The GONG LED lights or blinks during the transmission of a gong signal. What kind of gong signal is being transmitted is defined during the configuration procedure. Pressing the STOP key cancels the reproduction of the gong signal.

While in setup-mode, this key is used to return to ‘normal’ user mode (ESCAPE = leaving setup-mode).

PROANNOUNCE System User Handbook 1.1 5-31