Dynacord DPM 4000 manual Appendix, 6.1PROANNOUNCE Hardware Configuration 6.1.1 DCS

APPENDIX

6.Appendix

6.1PROANNOUNCE Hardware Configuration

6.1.1 DCS 400

When configuring and initially operating the DCS 400 system, please proceed as follows:

1. Cabling

➨Use the supplied flat-wire cable for connecting the relay modules DCS 408, DCS 409 in the desired order to the control module DCS 401. Mixed installation of relay modules is possible; numbering the relays is type-specific and has to be performed according to their sequence.

example:

Sequence		Module		Line relay No.				Control relay No.
1		DCS 408	1		-	5
2		DCS 408	6 - 10
3		DCS 409					1 - 5
4		DCS 408	11		-	15
5		DCS 409					6 - 10
6		DCS 408	16		-	20
...	...				...		...

➨Use the supplied flat-wire cable for connecting the logic input module DCS 412 to the control module DCS 401. Numbering the logic inputs has to be performed according to their sequence.

example:

Sequence		Module		Logic input No.
1		DCS 412	1 - 12
2		DCS 412	13 - 24
3		DCS 412	25 - 36
...	...		...

➨ Use the supplied flat-wire cable for connecting the analog input / output modules DCS 416 to the control module DCS 401. Numbering the analog inputs and outputs has to be performed according to their sequence.

example:

Sequence	Module		Analog input No.		Analog output No.
1	DCS 416	1 - 8		1 - 8
2	DCS 416	9 - 16		9 - 16

➨ Connect the control module DCS 401 via RJ-45 cable to the REMOTE CONTROL socket on the DPM 4000.

PROANNOUNCE System User Handbook 1.1 6-1