DEVICE DESCRIPTIONS
5.1.9MIC/LINE + Paging Station Module (NRS 90234)
This
Next to the electronically balanced audio input, the DPC 4000 input connector provides a serial
The MIC / LINE input employs an internal switch (PAD) providing 30 dB of attenuation. The
can be switched via jumper. If necessary, a compressor / | figure 5.22 MIC/LINE + paging station module (NRS 90234) |
limiter circuit can be incorporated in the audio path. |
|
Input channels can be switched separately to the monitor |
|
bus and you can listen to the signal via headphones or |
|
loudspeaker, either which being connected to the monitor |
|
output. Automatic pilot tone surveillance of the entire |
|
input stage is integrated as well. |
|
Note: When connecting several paging consoles to a single input, please keep in mind that line interruption or
Specifications:
description | |||
connections | 1 x | ||
input A | DPC 4000, electronically balanced, transformers are optionally available | ||
nominal input level | 0 dBu / 775 mV |
| |
max. input level | +12 dBu / 3 V |
| |
input impedance | 20 k |
|
|
input B | MIC/LINE, electronically balanced, transformers are optionally available | ||
nominal input level | MIC: | 1.5 mV ... 155 mV | |
| LINE: | 50 mV ... 5 V | |
max. input level | MIC: | +5 dBu / 1.4 V |
|
(in limiter operation) | LINE: | +30 dBu / 25 V |
|
input impedance | MIC: | 3.6 k |
|
| LINE: | 10 k |
|
Phantom power | 24V / 20 mA, switched via jumper | ||
audio |
|
|
|
input balancing | > |
|
|
frequency response | 20 Hz ... 20 kHz, 0.5 dB |
| |
S/N ratio | > 95 dB |
| |
distortion | < 0.01 % |
|
|
| |||
control interface | 1 x |
|
PROANNOUNCE System User Handbook 1.1 |