DEVICE DESCRIPTIONS
Optional Key-lock Switch (NRS 90231)
The paging consoles employ two empty slots for the incorporation of optional alarm keys or
Brief description: | optional |
| idling |
Supplied with the NRS 90231: 1
1connection cord,
1resistor 10 k ohms
Installation instruction:
1.Disconnect the paging console from the power supply.
2.Detach the bottom plate (6 to 8 screws, depending on the paging station model).
3.Prepare the installation site for the insertion:
Use a sharp, pinpoint tool (needle, pointed
Note: Please make sure to solder the cables after the switch has been installed. Otherwise it is virtually impossible to slide the milled nut over the body of the switch!
4.Adjust the switch and tighten it using the supplied milled nut.
5.Please refer to the circuit diagram on this page when
connecting the supplied
6. Please mind the sequence in which you connect the flat wire cables. The two outside wires 1(rt) and 4(gr) have to be cut off as short as possible and need to be insulated. The two inner wires 2(gr) and 3(gr) need to be soldered to contacts 1 and 2 of the switch. Polarity is not a critical factor.
7. Afterwards, you have to connect the
8.
9.Software configuration with the PROANNOUNCE Designer
figure 5.40 | circuit diagram |
PROANNOUNCE System User Handbook 1.1 |