1.3PROGRAMMING OUTLINE
Use the following programming outline to guide you through the steps required to set up the
1. SETUP RA-2400 SOFTWARE
✦Install the software on your computer (Section 1.4).
✦Test your computer’s modem (Section 1.5).
✦Start the
✦Set the Communications Setup options (Section 3).
2. CUSTOMIZE AN ACCOUNT PROFILE
✦Open a new Account Profi le (Section 4.1).
✦Enter customer information (Section 4.2).
✦Set the Console’s access codes (Section 4.3).
✦Set the Console’s arm/disarm options (Section 4.4).
✦Set the Console’s exit/entry delays (Section 4.5).
✦Set the Console’s alarm options (Section 4.6).
✦Set the Console’s
✦Set the Console’s audio options (Section 4.8).
✦Enable the Console’s communicator and choose a communicator format (Section 4.10).
✦Choose the communicator’s account number, telephone numbers, and trouble report routing (Section 4.11).
✦Set the communicator reporting options (Section 4.12).
✦Set the communicator format reporting options (Section 4.13 or 4.14).
3. PROGRAM THE CONSOLE WITH THE ACCOUNT PROFILE
✦Choose an Account Profi le (Section 5.2).
✦Connect to the Console (Section 5.3).
✦Send the data to the Console (Section 5.4).
✦Receive the data from the Console (Section 5.5).
✦Change the Console’s Mode (Section 5.6).
✦Disconnect from the Console (Section 5.7).
IMPORTANT:
AFTER ANY PROGRAMMING CHANGES ARE MADE TO A CONSOLE, PERFORM THOROUGH TESTING TO VERIFY THAT THE CONSOLE OPERATES AS INTENDED.
3