Linear DVS-1200, DVS-2400, RA-2400 manual 4.4CONSOLE ARM/DISARM, Purpose, User Response, Arm/Disarm

4.4CONSOLE ARM/DISARM

PURPOSE:

To select which modes any remote arm/disarm transmitters will switch to. Also for selection of fi ve arm/disarm options.

USER RESPONSE:

ARM/DISARM

✦TOGGLE-ARM TO: Select either HOME or AWAY to choose the mode that any remote arm/disarm transmitters will arm the Console to.

✦TOGGLE-DISARM TO: Select either OFF or CHIME to choose the mode that any remote arm/disarm transmitters will disarm the Console to.

✦CHIRP ON REMOTE ARM/DISARM: When arming with the portable remote control, if this box is checked the Console will “chirp” once when armed, twice when disarmed, and three times when arming with sensors bypassed. Un-check this box to silence the “chirps”.

✦AUTO-BYPASS:If this box is unchecked, the user must manually bypass any open sensors when the system is armed. If arming is attempted with open sensors, the Console will sound fi ve two-tone beeps and will not arm. Arming to the same mode again within fi ve seconds will bypass any open sensors and arm the Console. Check this box and the Console will automatically bypass any open sensors when the system is armed.

✦BYPASS-RESTORAL:Bypassed sensors are ignored by the Console and cannot cause an alarm. If this box is checked, the Console will automatically restore (remove the bypass from) any bypassed sensor when the sensor closes. After it’s restored, the sensor is ready to cause an alarm the next time it is opened. Un-check this box to not automatically restore sensors that close.

✦ALLOW QUICK-ARM:If this box is checked, it allows the Console to be armed by holding down a mode key for two seconds. Un-check this box and an access code must be entered before pressing the mode buttons.

✦HOME AUTOMATION OUTPUT ACTIVE WHILE ARMED: If this box is checked, the Console’s Automation Output will activate when the system is armed. Un-check this box to disable this feature.

19