Door Station Rough-In
VMC1VDS-S/BZ Door Station Rough-in | VMC1HR Rough-in Enclosure |
The VMC1VDS-S and VMC1VDS-BZ incorporate a wide angle 120 degree horizontal viewing camera into a Door Station. It is normally mounted at a height from the floor of: 55” – 60”. Installation of this unit on an exterior wall requires 4 screws and anchors (See Figure 6). When installing these units, be aware of the camera location and the direction of sunlight and other ambient light. Direct sun or light pointed into the lens of the VMC1VDS camera may impact video quality. Additionally, exposure to extreme weather conditions is not recommended. For added protection against weather, the VMC1VDS-S and VMC1VDS-BZ should be equipped with a DSWS weather shield. The installation of the DSWS is provided in the VMC1 Finish Out Guide.
1.Attach the VMC1HR flush to the exterior wall using the two inner pre-punched holes in the VMC1HR.The outside holes on the wings of the box are to be used to mount the VMC1VDS-S/BZ and not to be used to attach the VMC1HR to the exterior wall.
2.Pull the Cat-5 wires through the hole in the back of the VMC1HR and loop it through so they do not fall back into the wall.
3.If the door strike or Chime activated Control Output is to be utilized, see “Door Release Rough-in and “Chime Activated CO Rough-in
PRE-DRYWALL COLOR VIDEO DOOR STATION
USE INNER HOLES FOR
MOUNTING ROUGH-IN
ENCLOSURE TO STUD
VMC1VDS-BZ
VMC1VDS-S
7-3/4”
VMC1HR
3-1/2”
CAT5 CABLE LOOPED
WITH EXCESS AMOUNT
COLOR VIDEO DOOR
STATION WALL
MOUNTING PLATE
ELECTRONICS
PANEL
VMC1VDS-BZ
VMC1VDS-S
DRYWALL
ANCHORS
POST-DRYWALL COLOR VIDEO DOOR STATION
Figure 5. VMC1VDS-S/BZ Door Station Rough-In
