Manuals / Linksys / Computer Equipment / Network Router

Linksys WRVS4400N manual Status Tab, WAN / Gateway, Internet Connection

Models: WRVS4400N

1 134

Download 134 pages 37.56 Kb

Page 88

Wireless-N Gigabit Security Router with VPN

Status Tab

The Status Tab provides current status on this Wireless Router including WAN, LAN, Wireless LAN, System Performance, VPN client connections, and IPsec VPN connections.

WAN / Gateway

This screen provides some basic information on the Wireless Router (e.g. firmware version, time) and WAN port MAC/IP address and connection status.

Firmware Version. Displays the current firmware version.

MAC Address. Displays the WAN port MAC Address, as seen by your ISP.

Current Time. Displays the time on this Wireless Router according to your settings on the Setup->Time tab.

Internet Connection

Connection Mode. Displays the Internet connection type setting on WAN port.

Interface. Displays the WAN port Interface status (Up or Down).

IP Address. Displays the WAN port IP Address.

Subnet Mask. Displays the WAN port IP subnetmask.

Default Gateway. Displays the default Router to reach Internet or other networks from the WAN port. DNS. Shown here are the DNS (Domain Name System) IP addresses currently used by this Wireless Router.

DHCP Release button. Click this button to release IP address on WAN port if using DHCP. DHCP Renew button. Click this button to renew IP address on the WAN port if using DHCP.

Chapter 6: Setting Up and Configuring the Router

Figure 6-68: Status - WAN / Gateway

80

Status Tab

Image 88

Linksys WRVS4400N manual Status Tab, WAN / Gateway, Internet Connection

Contents

Wireless-N Gigabit Security Router with VPN Copyright and Trademarks How to Use this GuideWord definition Table of Contents Appendix C Configuring a Gateway-to-Gateway IPSec Tunnel Appendix F SpecificationsAppendix G Warranty Information Appendix E GlossaryList of Figures Example network11 Setup LAN 41 VPN IPsec VPN 72 Status Wireless LAN 71 LAN ARP TableIntroduction WelcomeWhat’s in this Guide? Wireless-N Gigabit Security Router with VPN Networking and Security Basics An Introduction to LANsUse of IP Addresses Networking and Security BasicsNetworking and Security Basics Use of IP Addresses Intrusion Prevention System IPS Wireless-N Gigabit Security Router with VPN Planning Your Virtual Private Network VPN Why do I need a VPN?Packet a unit of data sent over a network What is a VPN? Computer using the Linksys VPN client software to VPN Router VPN Router to VPN RouterPower Getting to Know the RouterDiag Back Panels Stackable Position and its Antenna Setup Antennas and PositionsConnecting the Router OverviewConnection Instructions Connect a PCPlacement Options Stand OptionMounting Dimensions Wall-Mount OptionSetting Up and Configuring the Router Basic SetupHow to Navigate the Utility How to Access the Web-based UtilitySetup Wireless FirewallAdministration QoSL2 Switch StatusSetup Tab IP VersionsInternet Connection Type Automatic Configuration DhcpStatic IP PPPoE PptpHeart Beat Signal Setup WAN Heart Beat SignalL2TP Optional Settings Required by some ISPs Setup WAN Optional SettingsDynDNS.org TZO.comServer Settings Dhcp IPv4IPv6 DMZ MAC Address CloneAdvanced Routing Operating ModeDynamic Routing 15 Setup Advanced Routing Routing Static Routing16 Setup Time TimeBasic Wireless Settings Wireless TabBasic Settings Setting Up and Configuring the Router Wireless Tab Wireless Security Wireless SecurityDisabled WPA-Personal also known as WPA-PSKWPA2-Personal WPA2-Personal MixedWPA-Enterprise WPA2-EnterpriseWPA2-Enterprise Mixed WEPWireless Connection Control Wireless Connection ControlWireless Client List Connection ControlAdvanced Wireless Settings Advanced WirelessSetting Up and Configuring the Router Wireless Tab Basic Settings Firewall TabRestrict WEB Features IP Based ACL Source Interface Select LAN, WAN, or ANY interfaceEdit IP ACL Rule New RuleScheduling Internet Access Policy 34 Firewall Internet Access Policy35 Firewall Internet Access Policy Summary Single Port Forwarding 37 Firewall Single Port ForwardingPort Range Forwarding 38 Port Range ForwardingPort Range Triggering 39 Port Range TriggeringService 40 Firewall ServicesVPN Tab IPsec VPNLocal Security Group Remote Security GroupKey Management Auto IKEManual 43 View VPN Tunnel LogAdvanced Settings Phase 1 and Phase 44 IPsec VPN Advanced SettingsSetting Up and Configuring the Router VPN Tab VPN Client Accounts VPN Client List TableVPN Passthrough 46 VPN VPN PassthroughQoS Tab Application-basedPort-based 48 Port-basedLocal Gateway Access Administration TabManagement 50 Administration Log LogPing Test Parameters DiagnosticsTraceroute Test Parameters Save Configuration Config ManagementRestore Configuration Factory Defaults Firmware UpgradeIPS Tab ConfigurationAbnormally Detection Peer to Peer Instant MessengerAttacker ReportAttacked Category Information 62 IPS InformationL2 Switch Tab Vlan ConfigurationRadius Port Settings Port. Specifies the number of the four LAN portsCable Diagnostics 67 L2 Switch Cable DiagnosticsWAN / Gateway Status TabInternet Connection 69 Status LAN Wireless LAN 72 Status Wireless LANL2 Switch Ports System PerformanceVPN Clients 74 Status VPN ClientsAppendix a Troubleshooting Common Problems and SolutionsFor Windows 98 and Millennium Need to set a static IP address on a PCFor Windows For Windows XPFor Windows 98 and Millennium Wireless-N Gigabit Security Router with VPN Am not able to access the Router’s Web-based Utility Setup Need to set up a server behind my RouterApplication Start and End Protocol IP Address Enable TCPApplication Start and End Protocol IP Address Enabled Can’t get the Internet game, server, or application to workTo start over, I need to set the Router to factory default Need to upgrade the firmwareFor Microsoft Internet Explorer 5.0 or higher For Netscape 4.7 or higherFirmware upgrade failed My DSL service’s PPPoE is always disconnectingNeed to use port triggering Frequently Asked Questions Where is the Router installed on the network?Is IPSec Passthrough supported by the Router? Does the Router support IPX or AppleTalk?What is Network Address Translation and what is it used for? How can I block corrupted FTP downloads?What is DMZ Hosting? Router allows Pptp packets to pass throughIs the Router cross-platform compatible? How many ports can be simultaneously forwarded?Which modems are compatible with the Router? How can I check whether I have static or Dhcp IP addresses?Before You Begin Figure B-1 VPN Client Accounts ScreenInstalling from the CD-ROM Installing the Linksys QuickVPN SoftwareDownloading and Installing from the Internet Using the Linksys QuickVPN Software Figure B-2 QuickVPN102 Appendix C Configuring a Gateway-to-Gateway IPSec Tunnel Figure C-1 Diagram of Gateway-to-Gateway VPN TunnelConfiguring the VPN Settings for the VPN Routers Configuring VPN Router105 Configuring the Key Management Settings Configuring PC 1 and PC Windows 98 or Me Instructions Windows 2000 or XP InstructionsFor the Router’s Web-based Utility Figure D-3 MAC Address/Physical AddressAppendix E Glossary 110111 112 113 114 115 Model Appendix F SpecificationsManagement Snmp Version Snmp Version 1, 2c QuickVPN Tunnels for remote client access MD5/SHA1 AuthenticationSecurity 3DES EncryptionQueues Network Vlan Support Port-based Vlan Any host IP address on LAN sideAppendix G Warranty Information Limited WarrantyAppendix H Regulatory Information FCC Statement121 122 123 124 125 Need to contact Linksys? Appendix I Contact InformationInformation section in this Guide