Setup English
There are differences in the method of performing loudspeaker calibration on a standard | Range: |
EXOTIK and an EXOTIK+DA: | Default setting: 0 dB |
|
Standard EXOTIK
You will need a test disc that contains a tone signal for each loudspeaker in your system. Your specialist Linn retailer may be able to supply you with a suitable disc.
To perform speaker calibration:
●Add a Linn UNIDISK player to the EXOTIK by following the setup instructions on page 16.
●Exit setup and change source to ‘UNIDISK’.
●
●Play the tracks on the test disc for speaker calibration while selecting the appropriate loudspeakers from the EXOTIK’s menu.
●If the tone signal coming from a particular loudspeaker is louder or quieter than from the other loudspeakers, use the 
/ 
keys on the handset to trim the volume as required.
Select SAVE to save your changes and return to the SPEAKER SETUP menu.
Select BACK to return to the SPEAKER SETUP menu without saving changes.
Select EXIT to leave setup (if changes have been made and SAVE has not been selected, you will be prompted to save or not save the changes).
Select BACK to return to the MAIN MENU.
Select EXIT to leave Setup.
Source setup
EXOTIK+DA
To perform speaker calibration:
●Select CALIBRATION LEVEL. Adjust the calibration level so that the signal you hear is at a comfortable listening level (or reaches a preset level on an SPL meter).
●Select START. The signal will move round the loudspeakers in your system in a clockwise direction and will be indicated on the display.
●When the signal reaches a loudspeaker which is louder or quieter than the other loudspeakers, use the 
/ 
keys on the handset to trim the volume as required. A few seconds after the 
or 
key has been released the signal will continue its clockwise direction.
●To exit loudspeaker calibration, press SETUP on the handset or SELECT on the front panel.
Select the back panel input you wish to use with your source component. Please complete the source setup procedure for each source component you are connecting to your EXOTIK.
Options: ANALOG GROUP, ANALOG 1 to 6, SPDIF 1 to 3*, TOS (TOSLINK) 1 to 3*,
KNEKT.
Notes:
If you are not using a UNIDISK player and wish to use the input(s) assigned to a UNIDISK player, enter the UNIDISK SOURCE menu and set ANALOG SOURCE and DIGITAL SOURCE* to NONE (see page 14).
The ANALOG GROUP uses the ANALOG 1, 2 and 3 inputs, therefore if a source is assigned to ANALOG GROUP you cannot also assign a source to ANALOG 1, 2 or 3. Conversely, if a source is assigned to ANALOG 1, 2 or 3, you cannot assign a source to
ANALOG GROUP.
*EXOTIK+DA
EXOTIK
9 | Owner’s Manual |
