SLEEP TIMEOUT
Set the time elapsed before the front panel display enters sleep mode (i.e. shows three dots) after a key on the front panel or handset is pressed.
Options: NEVER SLEEP, IMMEDIATE, 30 SEC., 5 MINS.
Default setting: NEVER SLEEP
STARTUP SOURCE
Set the source the unit selects when brought out of standby.
Options: LAST USED, NONE, (any of the source inputs)
Default setting: LAST USED
STANDBY RECORD FROM
You can record from a source component to a recording device through the EXOTIK, even if the EXOTIK is in standby mode.
Set which source configuration you want the EXOTIK to select when it is in standby.
Options: LAST USED, NONE, (any of the source inputs), AS KNEKT*
Default setting: LAST USED
KNEKT
If your EXOTIK is installed in a Linn KNEKT
Options: NONE, MAIN ROOM, LOCAL ROOM, INTERSEKT
Default setting: NONE
ACCESSORY SOCKET
Define the use of the accessory (ACC/RCU) socket on the back panel.
Options: RCU* (KNEKT Room Control Unit), IR (Infrared Repeater)
Default setting: RCU
*For use with Linn KNEKT systems.
Setup English
PRODUCT IR
Enable or disable the infrared receiver on the front of the unit.
Options: ENABLE, DISABLE
Default setting: ENABLE
RS232 Setup
Accesses the RS232 SETUP
The RS232 Setup
BAUD RATE
Set the baud rate to suit the RS232 protocol being used.
Range: 1200 to 230400 (11 settings)
Default setting: 9600
PARITY
Set parity to suit the RS232 protocol being used.
Options: EVEN, ODD
Default setting: EVEN
DATA BITS
Set the data bits to suit the RS232 protocol being used.
Options: 7, 8
Default setting: 7
STOP BITS
Set the stop bits to suit the RS232 protocol being used.
Options: 1, 2
Default setting: 1
EXOTIK
13 | Owner’s Manual |