AUXILIARY Input
R
www.ListenTech.com
3
2
1
3
2
1
The
- | AUXILIARY Balanced Audio Input: | |
| The nominal input level for the balanced input is 0dBu. | |
+ | Female XLR / ¼ in combination connector pin outs: | |
Pin 2 (tip) + | ||
| ||
| Pin 3 (ring) – | |
| Pin 1 (sleeve) Shield |
- | AUXILIARY Unbalanced Audio Input: |
| The nominal input level for the two unbalanced inputs is |
+ | Female XLR / ¼ in combination connector pin outs: |
| Pin 2 (tip) + |
| Pin 1 and 3 ring/sleeve |
Speaker Connection
The
i.The Speaker Selection switch determines what audio is directed to the power ampli- fier. With the switch in the OUTPUT position, the OUTPUT audio (same audio that is on the OUTPUT audio connectors) is directed to the power amplifier. With the switch in the AUX position, AUXILIARY input audio only is directed to the power amp. This allows you to use the power amplifier separate of the RECEIVER audio if desired.
Note: When the speaker switch is in the OUTPUT position and the MUTE control is enabled (indicated by the illumination of MUTE LED), the speaker output is also muted.
ii.Connection to the speaker is achieved through pins 1 and 2 on the detachable termi- nal block. Strip the speaker wires, rotate the screws on the terminal block counter- clockwise, insert the wires and then tighten the screw clockwise until the wire is secure in the connector block. You may connect any parallel, series combination of speakers that produces an impedance of
LISTEN TECHNOLOGIES CORPORATION 8535 South 700 West, Suite A Sandy, Utah
12