Initial installation
Turning the set on/off
Switching the TV set to standby mode
Activate the mains switch on the bottom left of the set.
The display in the control panel on the front of the set will be illuminated red, the set is now in standby mode.
Switching the TV on/off on the control unit
Press the on/off button in the middle for about 2 seconds to switch the TV set on/off.
Display | Meaning of the display colour: | |||
|
|
| ||
|
|
| Red: | Standby mode |
|
|
| Green: | TV set is switched on |
|
|
| ||
Orange: Radio mode, TV set receives EPG data or timer recording active
Switching the set on with the remote control
Press the on/off button
or
numeric buttons
or
TV button
or
OK button – station list is called
or
ASSIST button – Assist+ menu is called.
Switching the set off with the remote control
Press the on/off button.
➠Before switching off the set with the mains switch, we recommend you to switch it to standby mode.
Switch on in Radio mode
Press R on the TV control unit.
or:
Press the RADIO button on the remote control (radio mode, see page 34).
First installation wizard
First installation after switching on for the first time
This wizard starts automatically after the set is switched on for the first time, however it can also be called later manually in the TV index, see Repeat initial installation on page 16.
First installation wizard
Which language do you want to use for operation?
Initial installation
Language
| Sprache | D |
| Kieli | FIN |
|
| Language | GB | OK | Jezik | SLO | |
| Langue | F |
| Jazyk | SK | |
| Lingua | I |
| Lisan | TR | |
| Idioma | E |
| Språk | S | |
| Taal | NL |
| Sprog | DK | |
| Jazyk | CZ |
| Idioma | P | |
| Γλώσσα | GR |
| Язык | RUS | |
| Język | PL |
| Språk | N | |
| Nyelv | H |
|
|
|
|
| OK Proceed |
|
|
|
|
|
|
|
|
|
|
|
|
The first step with the wizard starts when selecting the language for the user prompts. From this point on follow the instructions on your TV set.
Brief explanation of button functions:
Press the ring (up, down, left, right) to move the cursor and to select settings.
By pressing the OK button a setting is confirmed and you will go to the next step.
With the yellow button you can select or remove the indi- vidual items (see the example below).
When an element is selected, it is marked by a check- mark .
Use this button to go back one step.
Exit the wizard with the END button (if available).
Initial installation
Connect antenna cable(s)
Antenna cable(s) for: | to antenna socket(s): | |
Antenna/cable (analogue) | ANT TV | |
ANT TV | | |
ANT TV |
| |
ANT SAT | | |
ANT SAT2 |
| |
OK Proceed | Connect/disconnect | |
| Back |
|
An example of multiple selection using the yellow button.
continued on the next page
- 12
