Loewe A 26, A 26 DVB-T, A 26 DVB-T CI Operating additional equipment, Login and connect equipment

Operating additional equipment

Login and connect equipment

You have logged in and connected all connected equipment in the initial start-up. If you want to connect other equipment or disconnect equipment, call the connection wizard.

Call up the TV menu

OK	Mark “Connections”
OK	Mark the submenu line
OK	Mark “New devices/modifications“ and ...
OK	call with OK.

State what equipment you want to connect. The connection wizard then shows you which sockets you should connect this equipment to. Then con- nect the equipment to these sockets.

Connecting video/DVD recorders

In addition to the connection via the Euro-AV sockets you also have to con- nect the antenna (only for terrrestrial antenna or cable systems) through the VCR/DVD recorder to the TV set. The antenna signal is then available to the video/DVD recorder and the TV set.

Note: Use Euro AV cables with righ-angled plugs as shown.

AV1	ANT-TV
	ENTREE
	ANTENNE
	EURO AV2
	DECODER

	AUDIO		AERIAL
	SORTIE	OUT
EURO AV1	G	L	SORTIE
AUDIO/			ANTENNE
VIDEO	D	R

RF OUT

Search for and store the station of the video recorder (if no Euro AV cable is available)

Switch on the test station on the VCR or insert a recorded tape and start playback. In some video recorders the station must be switched on by activating the modulator.

Then call the AV selection on the TV set with 0 AV. Select the menu item “VIDEO“ in the AV selection and call with OK.

To prevent “normal” TV stations being found in the search, pull out the antenna plug from the antenna input of the VCR temporarily (the cable to the antenna system).

If you cannot see the test station or playback from the cassette, the VCR is transmitting on a different channel. You then have to search for the station or set it manually.

1.Call the TV menu with the MENU button.

2.Select the „Settings“ menu item with .

3.	Select the line below it with	and “Channels“ with	.
4.	Select the line below with	and “Manual adjustment“ with		and
	call this menu with OK.

5.Enter channel “E30“ under the “Channel“ item (UHF range, select in this menu above if necessary).

6.Start search with the blue button.

7.If the station has been found, enter the name, confirm with OK and save with the red button.

8.A list of the stored stations is displayed.

9.Select 0 (VIDEO) here and overwrite this program place with the red button.

10.Hide the menu again with the MENU button.

Plug the antenna plug back in.

If you now get interference because a TV station is transmitting on the same channel as the VCR station, you have to change the transmitting sta- tion on the VCR and search for the VCR station on the TV again.

21