Lopi 1750 owner manual Optional Equipment, Rear Blower Installation

Optional Equipment 35

Rear Blower Installation (Part # 99000138)

The rear blower improves heat transfer by pushing heated air through the convection channel. Operating instructions are described in the section "Blower Operation".

a

Bend the legs on the snap disk assembly until it is approximately 1-5/8” thick. This will help it fit tightly into the rear convection channel.

1-5/8”

b

Remove these two knock-outs on the bottom of the stove (use a screwdriver to pry them out).

c

Twist the wires together on the snap disk assembly. Wedge the snap disk into the rear convection channel. Make sure the snap disk contacts the firebox (not the back of the convection jacket).

f

Attach the blower to the stove with the three screws included with the blower.

3/8" Wrench

d

Attach the wires from the thermodisk to the wires from the blower.

e

Position the blower near the rear of the stove. Tuck all excess wire into the blower box, making sure it does not contact any moving parts. Make sure when installing the blower, these wires do not become loose.

g	Plug the blower in. Do not route the power cord under or over the stove or in a
	location where it may become damaged.

© Travis Industries 100-01179 4060926