Optional Equipment

33

Front Blower (part # 99000133)

To Switch The Power Cord To The Left Side:

Use a pair of pliers to disconnect the strain relief which holds the power cord in place. With the power cord slackened, the molex connectors that attach the power cord to the blower assembly may be disconnected. Pry the button plug from the left side of the blower assembly and insert it into the hole on the right side. Pull the left side molex connector out from behind the deflection plate and cut the nylon tie that holds the wire back. Insert the molex connector on the power cord through the hole on the left side of the blower assembly and attach it to the left side molex connector. Route the wire directly behind the blower cage. Place the strain relief over the power cord (it should be in the same location on the power cord that it was before – approximately 2" from where the wires split). Insert the strain relief into the hole on the left side until the strain relief locks in place. Make sure the power cord, wires, or molex assembly do not protrude into the opening of the blower.

The wires tuck in here, directly behind the blower cage.

Remove the strain relief by

squeezing it from the top and bottom

with a pair of slip-joint pliers.

Disconnect the molex plug inside the blower assembly. Remove the power cord by pulling it out of the hole exposed by removing the strain relief.

Left Side of

Blower

Assembly

Remove the button plug from the

left side and insert it into the hole

on the right side.

Installation Instructions

1.Remove the two screws above the air control and beneath the ashlip. Place the blower assembly underneath the ashlip and replace removed the two screws. Before tightening the screws with a 3/8" nutdriver, lift the blower up so it tucks underneath the ashlip.

Remove the two screws here

3/8" Nutdriver

Use a 3/8" nutdriver to replace the two screws and hold the front blower to the appliance.

Plug the blower into a 110 volt grounded outlet.

Control Box

2. Plug the power cord running from the control box into a grounded 110 volt electrical outlet.

© Travis Industries

100-01162

4041105

Page 33
Image 33
Lopi Freedom Fireplace Insert owner manual Front Blower, To Switch The Power Cord To The Left Side