Lopi Freedom Fireplace Insert owner manual Drafting Performance, Leveling Bolt Installation

10 Installation (for qualified installers only)

Drafting Performance

This appliance relies upon natural draft to operate. External forces, such as wind, barometric pressure, topography, or factors of the home (negative pressure from exhaust fans, chimneys, air infiltration, etc.), may adversely affect draft. Travis Industries can not be responsible for external forces leading to less than optimal performance.

Leveling Bolt Installation

Two leveling bolts are included to level the insert if the fireplace has a stepped-up hearth. To install, raise the rear of the insert up and insert the leveling bolts into the holes in the rear corners of the insert. Adjust the bolts until they extend the same height as the hearth steps up. After the insert is installed, fine-tune the leveling bolts to level the insert (see Figure 4).

This distance is the
hearth step-up. The
leveling bolts should
stick out this far from the	Fireplace
base of the insert.
Hearth

The leveling bolts go

into the holes at the

rear corners of the

insert.

Figure 4

© Travis Industries 100-01162 4041105