20
(i) ALARM: Selecting [OFF] disables PIR motion detection from
triggering any alarm.
Selecting [OSD] will allow alarms to be triggered, and the letters “AL” ill
appear on the screen of the camera location where the alarm is
taking place. A third option, [OSD+BUZZER] will both display
“AL” and emit a buzzer sound in the event of an alarm.
(ii) CH 1-4: Set the length of alarm time for each channel between
1~59 seconds. Additionally, you can select the Alarm Input. The
default setting is N/O (Normally Open.
NOTE Some alternative brand PIR motion sensors have a default setting of N.C.
(normally closed). In order to activate the alarm on such a PIR motion
sensor, change the setting to N.C.
5. MOTION SET - This sub-menu allows you to enable / disable the Pixel-
based Motion Detection function by channel and set its Sensitivity level.
(i) MOTION : Selecting [OFF] disables the Pixel-based Motion
Detection function. Selecting [OSD] will allow motion to trigger
alarms, and the letters “MD” will appear on the screen of the
camera location where the motion is taking place. A third option,
[OSD+BUZZER] will display “MD” and emit a buzzer sound in the
event that motion is detected.
(ii) CHANNEL : Select which channels will have the Pixel Motion
Sensing feature activated. The Sensitivity level can be set to
zero for a channel, which will disable the Motion Sensing ability
for that channel.
(iii) SENSITIVITY : Select the sensitivity level of the Motion Sensing
by channel.
Level 05 is the highest sensitivity, Level 01 is the least sensitive.
Level 00 deactivates Motion Sensing.
(iv) AREA : Select the area of the screen where the Pixel Motion
Sensing feature will be active. The digits below represent the
area on the screen where motion is detected.
[ 00 ] - Whole screen. [ 01 ] - Top left side of screen.
[ 02 ] - Top right side of screen. [ 03 ] - Bottom left side of
screen.
[ 04 ] - Bottom right side of screen. [ 05 ] - Center of the screen.