STEP 1 - SET UP YOUR MONITOR FIRST



1

CONNECT CAMERAS TO THE MONITOR:

Connect the first camera to the CH1 input. Follow the same steps to connect the

additional cameras.

1.Connect the Female BNC end of the supplied 60’ extension cable to the camera. Connect the male Power end of the the extension cable to the camera.

2.Connect the Female end of the supplied 60’ extension cable to an open BNC camera input on the back of the System. Connect the female Power end of the the extension cable to one of end of the 4 in one power adaptor.

IMPORTANT NOTE: The ends of the extension cable are NOT the same - one end has a Male power port, and the other has a Female power port. Before permanently running the Camera Extension Cable, make sure that the cable has been oriented between the Camera and the unit correctly

2

CONNECT ETHERNET CABLE:

Connect one end of the ethernet cable to one of the router’s (not included) LAN

PORTS and the other end to Monitor’s Network Port located at the bottom of the monitor. See picture below showing a generic LAN/WAN connection.

LAN (LOCAL AREA NETWORK)

WAN (WIDE

AREA NETWORK)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BACK OF THE ROUTER SHOWN

TO YOUR MONITOR

TO YOUR COMPUTER

 

3

CONNECT THE MOUSE:

Connect the 6 PIN end of the Mouse included with your system to the PS2 port of

 

 

the monitor.

MOUSEAVAILABLECONTROL

4

CONNECT POWER CABLE:

Connect one end of the Power adaptor to the monitor, the other end to an electrical outlet. This unit powers ON once it is plugged in to the power outlet.

**After you see all four (4) camera images on your monitor screen, remove the protective film from camera(s) and monitor screen.

5

SET THE TIME AND DATE:

1. Press the MENU button from the Front Panel of the Monitor (or Remote Control), or use the

Mouse and Click the Menu Icon located at the bottom of the monitor screen (Show and hide screen becomes available when the Mouse pointer is placed at the bottom of the Monitor).

2.DVR LOG IN screen appears soon after the Menu button is pressed asking for a password. Note: USER ID BY DEFAULT IS ADMIN. Password is numeric and not necessarily needed for initial MENU setup. Press ENTER to enter the MAIN MENU.

3.On the MENU screen select CONFIGURATION and click ENTER.

4.Select TIME AND DATE SETUP to change or alter the factory default settings and press ESC to exit this menu.

Congratulations! You have completed Step 1 successfully. You can now view, record and playback images on your monitor.

Make sure that the Date and Time are set prior to recording.

L15LD400 Series Quick Set-up Guide R1

Page 3
Image 3
LOREX Technology L15LD400 Series specifications SET UP Your Monitor First, Connect Power Cable, SET the Time and Date