Alarm Set
Alarm Set
This submenu allows you to set the Alarm (based on Sensor or Motion input). When a Sensor event or Motion is detected, an Alarm EVENT will be triggered and an indicator will be displayed on the top left side of the monitor screen (see the QUAD screen diagram on the bottom of page 29).
1.DURATION - Sets the length of time an ALARM message is displayed on the monitor. Navigate to
this option using the buttons, and press the button to change the option to one of the following settings: 5 SEC / 10 SEC / 15 SEC / 20 SEC / 25
SEC / 30 SEC or CONT (Continuous Alarm).
2. CHANNEL1 - CHANNEL4 - Sets the Channel to ON/OFF for Alarm detection. Navigate to this
option using the buttons, and press the button to change the option.
When an ALARM is detected, an indicator appears at the top LEFT corner of the monitor screen. For example:
ALARM [ 1UU- ]
This indicates that Channel 1 is in ALARM, and the U displayed on Channels 2 and 3 indicate that these channels are set to NO (no ALARM). The - on channel 4 means that this channel is not currently in ALARM mode.
| ALARM | |
| DURATION | [ 5 SEC ] |
| CHANNEL1 | [ YES] |
| CHANNEL2 | [ NO ] |
| CHANNEL3 | [ NO ] |
| CHANNEL4 | [ YES ] |
[ | ]MOVE [ | ]SELECT []EXIT |
|
|
|
22
