Setting up the Wireless Receiver

Setting up the Wireless Receiver

To connect the wireless receiver to a surveillance recorder (DVR):

1.Screw the antenna onto the top of the receiver.

2.Connect the BNC connector on the receiver directly into an available video input.

NOTE: If necessary, attach the 3ft (1m) BNC/BNC extension cable at one end to the receiver and at the other end to the surveillance recorder.

3.Connect the power cable from the receiver to the Power Adapter; plug the Power Adapter to an outlet or surge protector.

To connect the wireless receiver to a TV or VCR:

1.Screw the antenna onto the top of the receiver.

2.Attach the included BNC/RCA adapter to the BNC connector on the receiver and plug the receiver directly into an available video input.

NOTE: If necessary, attach one end of the 3ft (1m) BNC/BNC extension cable to the receiver and at the other end attach the BNC/RCA adapter, and then connect the BNC/RCA adapter to the viewing/recording device.

3.Connect the Black power cable from the receiver to the cable of the Power Adapter; plug the Power Adapter to a local AC power outlet or surge protector.

NOTE: Use the included BNC/BNC extension cable in case the receiver is not able to properly connect into the viewing/recording device due to space constraints at the back/front of the device or to clear obstructions between camera and receiver which can affect wireless signal strength.

ATTENTION: Make sure to first connect and power on the camera(s) before powering on the receiver; this will ensure a proper connection.

Figure 2.0 Attach the receiver directly to an integrated system, TV, or DVR

11

Page 15
Image 15
LOREX Technology LW2100 Setting up the Wireless Receiver, To connect the wireless receiver to a TV or VCR