Setting Dwell Time
Setting Dwell Time
You can set the length of time (in seconds) that the receiver displays each channel while in Auto Scan.
To set dwell time:
1.Make sure the Wireless Receiver and cameras are fully connected and powered on.
2.Press and hold the RESOLUTION button and CHANNEL button at the same until the Dwell Time screen appears. Continue holding both buttons.
3.With the CHANNEL button and RESOLUTION button held down, the receiver will automatically cycle the dwell time from 1~20 seconds. The higher the dwell time, the longer each channel remains
4.Release both buttons to set the desired dwell time.
NOTE: If you repeat this process, the Dwell Time screen will display the last set dwell time.
Figure 7.0 Press and hold the RESOLUTION and CHANNEL buttons at the same time
Figure 7.1 Continue holding both buttons to set the dwell time for Auto Scan
15
