Lowrance electronic X135, X136DF, X125, X126DF manual Speed/Temperature Sensors

Place the transducer into the epoxy, twisting and turning it to force any air bubbles out from under the transducer face. The face of the transducer should be parallel with the hull, with a minimum amount of epoxy between the hull and transducer. After the epoxy dries, route the cable to the sonar unit.

Speed/Temperature Sensors

This unit accepts up to three temperature sensors which can monitor surface water, live well, bait well and virtually any other temperature. If you want to use more than one temperature sensor or a speed sensor, you must purchase the optional MY-4X adapter cable. You also need to be careful when purchasing the temperature sensors, because each temperature sensor has its own fixed electronic "address." The sensors are labeled "Water," "T-2" (or Temp-2) and "T-3" (or Temp-3).

The first "Water" temperature sensor is built into the transducer. This is the sensor that measures surface water temperature. If you want two (or more) temperature readings from other locations, you'll need to use the proper sensors. For example, you can't use two additional T-3 sen- sors. The sensors that fit this unit are:

• TS-1X	This sensor will over-ride the temperature sensor
	built into the transducer and over-ride the tem-
	perature sensor in a ST-TGY combination sen-
	sor. (This sensor is not recommended.)

•TS-2X

•TS-3X

•SP-X

•ST-TGY

One sensor for "T-2" temperature display.

One sensor for "T-3" temperature display.

One speed sensor for "Speed" display.

This combination sensor will provide speed and temperature readings, but the temperature reading will be displayed as the "Water" tem- perature because it will over-ride the tempera- ture sensor in the transducer. (This sensor is not recommended.)

See the wiring diagram on the following page for temperature and speed sensor combinations.

20