Luce PT-L6510E, PT-L6600E manual Using the Serial

Using the SERIAL

The projector is equipped with an RS-232C standard serial terminal at the rear. It is therefore possible to connect it to a computer for control.

Connection

• Single

Side interface panel

D-sub 9-pin (female)

SERIAL

PC

	Unit 1 interface panel
• Plural	D-sub 9-pin	D-sub 9-pin
	(female)	(male)
PC	IN	OUT
	SERIAL

Unit 2 interface panel

D-sub 9-pin	D-sub 9-pin
(female)	(male)
IN	OUT

SERIAL

D-sub 9-pin (male)

D-sub 9-pin	D-sub 9-pin
(male)	(female)

D-sub 9-pin (male)

Communication cable

Communication cable Communication cable

Pin assignments and signal names

D-Sub 9-pin (female) external appearance

Pin No. Signal name	Description
	NC
TXD	Send data
RXD	Receive data

	Connected internally
GND	Ground
	NC
CTS	Connected
RTS	internally
	NC

D-Sub 9-pin (male) external appearance

Pin No. Signal name	Description
	NC
RXD	Receive data
TXD	Send data
	NC
GND	Ground
	NC
RTS	Connected
CTS	internally
	NC

ENGLISH

Communication
	Signal level	RS-232C
requirements	Sync method	Start-stop transmission
	Baud rate	9 600 bps
	Parity	None
	Character length	8 bit
	Stop bit	1 bit
	X parameter	None
	S parameter	None

Basic format

Transmission from the computer begins with STX, then the command, parameter and ETX are sent in this order. Colon (:) is not required when transmitting the command which does not need a parameter.

STX

Start

Caution

AD		I 1	I 2		:		C1	C2	C3		:
	ID	characters
		(2 Bytes)		Colon						Colon
						Command 3 characters
		00 to 99					(3 Bytes)

ID designate

P1 P2 P3 P4 P5

Parameter

(1 to 5 Bytes)

ETX

End

•On commencement of lamp lighting, commands cannot be sent or responses received for approximately 10 seconds. Be sure to send any commands and receive responses 10 seconds. (Applies to the PT-L6600E / PT-L6600EL only)

•When transmitting several commands, wait for a response from the projector before sending the next command. When sending commands without parameters, a colon is not necessary.

•When it is unnecessary to designate an ID code, send the format without the part to ID designate it.

Note

•If a wrong command is received, the projector sends ER401 back to the computer.

•When using control from the remote terminal, commands cannot be received at the serial terminal.

•Projector ID supported on the RS-232C interface is 0 (ALL) to 99.

•The remote control ID is set from 0 to 3. If a command is sent with a projector ID specified, the projector will return answer back only if the ID contained in the command matches the projector ID or the projector ID is set to ALL.

37