Using the Remote control unit
Loading batteries
When loading batteries into the battery compartment of the remote control, make sure that their polarities are correct.
1. Open battery compartment lid.
Open lid in the order of steps 
and 
.
Effective control range
The remote control should normally be aimed at either the front or rear remote control receiver window on the projector (fig. 1). Otherwise it may also be aimed at the screen, which will reflect commands back to the projector's front receiver window as illustrated in figure 2.
The effective control range is approx. 7 metres (23 feet) immediately in front of the receiver windows.
2. Insert the batteries
Into battery compartment, with their polarities orientated as indicated (
/
) in the compartment.
Accessory
(Front)
Remote
control 30°
30° | [Top view] |
Remote control 15°
15°
[Side view]
fig. 1
(Rear)
°Remote
30 control
30°
Remote
15° control
15°
3. Close battery compartment lid.
Replace the battery compartment lid over the compartment and slide until it clicks.
Caution
•Exercise care not to drop the remote control on hard flooring.
•Exercise care not to spill water or any other liquid on the remote control.
•Do not use
Screen
projector
Remote control | Remote control |
receiver window | receiver window |
(Front) | (Rear) |
Remote |
|
control |
|
fig. 2 |
|
Note
•When the remote control is aimed at the screen, the effective control range may be reduced due to the optical loss of the screen.
•The remote control may not function properly if an object is in the light path.
•The remote control receiver may not function properly in intense ambient light. Carefully site the projector so its remote control receiver windows will not be directly exposed to intense light.
14
