Lucent Technologies 03.0.042.2 manual Change Descriptions, The following statements

Models: 03.0.042.2

1 16
Download 16 pages 60.75 Kb
Page 8
Image 8
Change Descriptions

Change Descriptions

8.Automatic Route Selection (ARS) calls were blocked (caller received reorder tone) when trunks were available but in a group controlled by the attendant. Under these conditions, a denial event will be logged when an ARS call fails and at least one of the trunk groups in a preference is controlled by the attendant.

9.It was possible to remove the administration for the TN802B or TN799B circuit packs even if an IP-interface was administered for that board.

10.VuStats could display a "percent in service" value greater than 100 percent.

11.Calls transferred to a station that covered could cause a system reset.

12.If a series of disconnects occurred in a very short time period, the Basic Rate Interface (BRI) trunk link state was put into a state that did not handle the hyperactive message from the packet interface board. As a result, the link was taken out of service for about twenty minutes. Now, the hyperactive state is handled and the link is taken out of service for about one minute.

13.Some calls to the attendant console could not be answered by the attendant, leaving the console locked up for several minutes until an audit cleared the condition. Now, if a console is in a temporary state where a new call can’t be answered, all incoming calls are directed to another console until the condition clears.

14.There were two display messages for which translations were not available.

15.If temporary bridged appearance for call pickup is set to "no" for the system, users were blocked from sending digits end-to-end using an auto-dial button, if the call was answered using a call pickup button.

16.If IP-Softphone A was bridged to another Station B, and C called B, then A answered. If another Station D called B and hung up after a ring, the call from C to A also dropped.

17.A DEFINITY Wireless Business Systems (DWBS) user on a switch configured for Russian country-specific options did not get the Russian interdigit timeout.

18.It was impossible to invoke Automatic Callback (ACB) over a QSIG Basic Rate Interface (BRI) trunk after a “reset system 2”. It was necessary to re-administer the maximum number of Non-Call Associated (NCA) Temporary Signaling Connections (TSCs) for the BRI trunk to get QSIG ACB working again.

19.The following statements:

1)It was possible to list all administered IP SoftPhones using the “list multimedia ip-softphone” command.

2)Access to the “list multimedia ip-softphone” command was blocked using the “mm-ip-softphone” keyword on the permissions form.

6 Release 8, Issue 3.0 (03.0.042.2)

Page 8
Image 8
Lucent Technologies 03.0.042.2 manual Change Descriptions, The following statements, Release 8, Issue 3.0