Lucent Technologies 03.0.042.2 manual

Change Descriptions

83.The switch reset when an agent exited AUX work mode.

84.Russian incoming toll intrusion on a call over a Russian 3-wire rotary trunk to a far end BUSY subscriber caused the caller’s station to enter a non-functional state, requiring a Busy/Release to return it to service. The Russian incoming toll intrusion attempt is now denied unless the far end subscriber has actually answered the call, and the caller’s station idles correctly when the station goes on-hook.

85.Executing a "display-error" command on a large (e.g., 240 members) trunk group could cause a system reset.

86.The Terminal Self Administration (TSA) feature could cause a system reset.

87.If call processing tried to access vector translations at the same time that these translations were being changed from CMS, a system reset could occur.

88.Technicians could not clear hyperactive alarms by using the busy/reset/release sequence on DS1 boards. The "reset board" command now executes Test #129 (Board Restore).

89.When a call redirects to the attendant due to Direct Inward Dialing (DID) No Answer Timeout, the display showed "a= XXX-XXX-XXXX to OPERATOR na". The display now shows "a= XXX-XXX-XXXX to called-station-name na".

90.When a data link was disconnected in a telecommuter phone call, the voice call was dropped within 10-60 seconds (most often within 10-30 seconds) following the warning of link disconnection by the endpoint. Now, the voice call is dropped within 40-120 seconds (usually 60-90 seconds) following the link disconnection warning.

91.The title "AAR/ AAR Shortcut Dialing" appeared on the custom form, and has been changed to "AAR/AAR Dialing without FAC" for the same functionality.

92.Under the following circumstances: an agent A who was observed by a supervisor received a call and answered, talked with the customer, pushed the transfer button and dialed an offnet number, then talked with the offnet number. When the agent A pushed the transfer button after the supervisor was bridged on, the call was dropped.

93.List occupancy would be very high after layer 2 would go down on a TN2158 BRI trunk port. This high occupancy could lead to degradation or loss of switch service.

94.Native mode H.323 IP stations were unable to make outbound calls.

12 Release 8, Issue 3.0 (03.0.042.2)