CALLMASTER®
IV Voice Terminal User and Installation Instructions
10
Installation Procedures
Use the following procedures to install your CALLMASTER IV voice terminal .
See Figure 3 for the location of the jacks mentioned below.
1Lay the voice terminal face down so the bottom slopes toward you.
2Plug the line cord into the 4-wire LINE jack for 4-wire operation; for 2-wire
operation, plug the line cord into the 2-wire LINE jack. Press firmly unt il
you hear the line cord click.
NOTE: If you plug the line cord into the wrong LINE jack, be advised that
the voice terminal will not work or it may be damaged.
3Press the line cord into the line cord routing channel, placing the cord
under the tab, and gently pull any slack from the cord to the rear of the
voice terminal.
4Turn the voice terminal rightside up so that the display is facing you.
5Plug the line cord into the modular wall jack. (Since the line cord i s 7-feet/
2.1336 meters long, your CALLMASTER voice terminal must be within
this distance from the wall jack.)
NOTE: You may also use a 14-foot/4.2672 meters line cord. To order this cord,
see “Orderable Equipment” earlier in these instructions.
Orderable Equipment (continued)
ITEM COMCODE PEC
Designation cards (set of 25) — German
Designation cards (set of 25) — Parisian French/
Belgian French
Designation cards (set of 25) — Brazilian
Portuguese
847933400
847933934
847933959
31795-CTR92
31795-CTR91
or -CTR39
31795-CTR43