Lucent Technologies Release 3 manual Assign Services to Called Numbers

Assign Services to Called Numbers

The system responds through the telephone:

The recorded phrase is: “Test, test, test.”

The system then returns to the INTUITY ChanTran main menu, starting with:

“Press 1 to initiate...”

NOTE:

If you heard the phrase, the test has completed successfully. If you did not hear the phrase, or the repeated phrase cannot be understood, the test has failed. Contact your remote maintenance center.

15.Press the star key to disconnect from the channel.

16.Hang up the phone.

17.Verify the disconnection by looking at the System Monitor screen. The channel should return to on hook.

NOTE:

If the channel returned to on-hook, the test completed successfully.

18.Test all remaining channels by repeating Steps 3 through 17 until all channels have been tested.

19.Press F6 (Cancel) until you reach the INTUITY Administration menu.

20.Continue with "Assign Services to Called Numbers".

Assign Services to Called Numbers

During installation, the voice channels must be assigned a service. This service tells the voice channels what to do with the incoming call.

The dialed number information service (*DNIS_SVC) provides the information INTUITY needs to correctly answer the incoming call. *DNIS_SVC allows channels to be flexible, so that each channel is able to handle different applications. This makes the system more responsive: if many calls come into the system for one of the applications at the same time, the INTUITY system can answer with as many channels as is needed, up to the maximum number permitted by hardware limitations.

Before *DNIS_SVC can be used, however, *DNIS_SVC itself must be administered. This administration involves identifying the service and the incoming called number that requires the service. The following procedure to assign the services and the called numbers must be performed before the *DNIS_SVC itself is assigned to the channels.

Issue 1 June 2000 A-13