XDM4600
Finishing the Zone Keypads
Figure 10—Zone Keypad Wiring
Figure 10 shows the wiring hookups for the backside connectors of the Zone Keypad (XDM46K). How to read the schematic:
1.The 16-gauge (power) and 18-gauge (for the speakers), 2-conductor wires attach to the 1x6 connector. The wire that provides power from the controller attaches where indicated by the label on the connector – the solid red indicates the position of the positive wire while the striped red indicates the position of the negative wire. The position of the speaker +/- L and +/- R is indicated by the L+, L-, R+ and R- lettering on the label.
2.The 1x10 connector attaches to the two CAT-5 cables. On the label, a heavy black line separates the connection of the two wires. Any unused wires are cut off. Refer to the connector label for the proper position of each color-coded wire. From top to bottom, the color code is as follows: blue/white, blue, green, orange, brown, and brown/white. This group is for the CAT-5 cable that goes to the wall plate. The remaining color codes are orange, orange/white, green, and green/white. This group is for the CAT-5 cable that carries the controller communication data.
How to Make the Connections
•Carefully strip insulation on wires from 3/16 to ¼ inch. Do not strip more than ¼ inch of insulation off of wire. Strip approximately 1/4 inch of insulation from each wire conductor.
•Attach all wires to their specific location as labeled on the connectors and as shown in the wiring connection detail.
M&S Systems 800.421-1587 www.mssystems.com | 17 |