Mabe Canada 21, 25 About the automatic icemaker, Instructions Operating Instructions Installation

About the automatic icemaker. ge.com

A newly installed refrigerator may take 12 to 24 hours to begin making ice.

Safety

Power		Automatic Icemaker (on some models)
Switch		Icemaker The icemaker will produce seven cubes
		per cycle—approximately 100–130 cubes
		in a 24-hour period, depending on freezer
		compartment temperature, room
		temperature, number of door openings
		and other use conditions.
Green		See below for how to access ice and reach
	Feeler Arm	the power switch.
Power Light
		If the refrigerator is operated before the
		water connection is made to the icemaker,
		set the power switch in the O (off) position.
		When the refrigerator has been connected
		to the water supply, set the power switch to
		the l (on) position. The icemaker power
		light will turn green when the freezer light
		switch is pressed in or when the freezer
		door is closed.
		The icemaker will fill with water when it
		cools to 15°F (–10°C). A newly installed
		refrigerator may take 12 to 24 hours to
		begin making ice cubes.

You will hear a buzzing sound each time the icemaker fills with water.

Throw away the first few batches of ice to allow the water line to clear.

Be sure nothing interferes with the sweep of the feeler arm.

When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together.

If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.

NOTE: In homes with lower-than-average water pressure, you may hear the icemaker cycle multiple times when making one batch of ice.

NOTE: Set the power switch to the O (off) position if the water supply is shut off.

Instructions Operating Instructions Installation

Shelf

Ice Bin

To reach the power switch.

Accessing Ice and Reaching

the Power Switch

Shelf

To reach the icemaker power switch, pull the shelf above the ice bin straight out. Always be sure to replace the shelf.

To access ice, simply pull the bin forward.

Ice Bin

To access ice.

Instructions

Icemaker Accessory Kit

If your refrigerator did not come already	Check the back of the refrigerator for
equipped with an automatic icemaker,	the specific icemaker kit needed for
an icemaker accessory kit is available at	your model.
extra cost.

Troubleshooting Tips

Dispenser Cradle

Spill Shelf

To Use the Dispenser

Press the glass gently against the top of the dispenser cradle.

The spill shelf is not self-draining. To reduce water spotting, the shelf should be cleaned regularly.

If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the dispenser arm for at least two minutes to remove trapped air from the water line and to fill the water system. To flush out impurities in the water line, throw away the first six glassfuls of water.

Locking the Dispenser

Press the LOCK pad for 3 seconds to lock the dispenser and control panel. To unlock, press and hold the pad again for 3 seconds.

Door Alarm

To set the alarm, press the DOOR ALARM pad. The indicator light will illuminate. This alarm will sound if either door is open for more than 2 minutes. The beeping stops when you close the door.

11

Consumer Support