Mabe Canada 21, 25 Locating the ANTI-TIP, Floor Bracket, ANTI-TIP Bracket Installation

Installation Instructions

2	LOCATING THE ANTI-TIP
	FLOOR BRACKET (cont.)
	Figure 2 – Acceptable Screw
	Placement Locations
	Preferred Installation –	Preferred Installation –
	Wood	Concrete
Minimum Acceptable #1 –		Minimum Acceptable #2 –
	Wall Plate Stud	Wood Floor
	Minimum Acceptable #3 –
	Concrete Floor

3ANTI-TIP BRACKET INSTALLATION

AWOOD Wall and Floor Construction:

•Drill the appropriate number of 1/8” pilot holes in the center of each floor bracket hole being used (a nail or awl may be used if a drill is not available)

AND remove the locator template from the floor.

•Mount the anti-tip floor bracket by fastening the 2, or preferably 4, #10-16 hex-head screws tightly into place as illustrated in Figure 3.

Figure 3 – Attachment to

Wall and Floor

BCONCRETE Wall and Floor Construction:

•Anchors required (not provided):

4 each 1/4” x 1 1/2” lag bolts

4 each 1/2” O.D. sleeve anchors

•Drill the recommended size holes for the anchors into the concrete at the center of the holes marked in Step 2.

•Install the sleeve anchors into the drilled holes. Place the anti-tip floor bracket as indicated in Step 2. Remove the locator template from the floor.

•Install the lag bolts through the anti-tip floor bracket and tighten appropriately.

CWOOD Wall and TILE Floor Construction:

•For this special case, locate the 2 wall holes identified in Fig. 1. Drill an angled 1/8” pilot hole (approx. as shown in Fig. 3) in the center of each hole.

•Mount the anti-tip floor bracket using the Minimum Acceptable Installation #1, as illustrated in Fig. 2.

4POSITIONING THE REFRIGERATOR TO ENGAGE THE ANTI-TIP FLOOR AND BASE BRACKETS

A Before pushing the refrigerator into the

opening, plug the power cord into the

receptacle and connect waterline (if

equipped). Check for leaks.

B Locate the refrigerator’s RH side and

move back approximately in line with the

RH side of the cabinet opening, W. This

should position the anti-tip floor bracket

to engage the anti-tip base bracket on the

refrigerator.

C Gently roll the refrigerator back into

the cabinet opening until it comes

to a complete stop. Check to see if

the refrigerator front lines up with the

cabinet front face. If not, carefully rock

the refrigerator forward and backward

until engagement occurs and you notice

that the refrigerator is fully pushed up

against the rear wall.

D OPTIONAL: Adjust the rear (and front)

Rear RH

Corner of the

Refrigerator

2 Screws	Floor
Must Enter	Bracket
Wood or
Metal Stud

Wall

Wall

Plate

Stud

wheel height settings to fully engage the

rear anti-tip brackets, while also aligning

the refrigerator front with the cabinet

front face.

NOTE:

Floor

19

If you pull the refrigerator out and away from the wall for any reason, make sure the anti-tip floor bracket is engaged when the refrigerator is pushed back against the rear wall.