Mackie Firewire OPtion Card fot Onyx Mixer 7

Set the blank plate aside. You won’t need it again, unless you want to remove the Onyx FireWire card sometime in the future. Then you’ll want to reinstall the blank plate.

4.Remove the FireWire card from the anti-static bag. CAREFULLY line up the connector on the ribbon cable with the connector on the back edge of the FireWire card and slide the connectors together, taking care not to bend any of the pins. Note that there is an alignment tab on the top of the ribbon cable connector that must align with the top of the connector on the FireWire card.

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

Manual Owner’s

Top of Onyx FireWire Card

5.Slide the FireWire card into the slot. There are two supporting “legs” on the back of the card. Angle the back edge of the card upward so the legs clear the edge of the slot in the back of the Onyx mixer. Line up the two holes in the plate with the screw holes in the back panel.

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

��	��
��	��
��	��
��
��
��	��
��	��

6.Secure the FireWire card in place with the two screws that previously held the blank plate in place. Two more screws are provided with your FireWire card. These go into the bottom of the Onyx mixer and secure the two support- ing legs on the back of the card to the chassis.

7.That’s it! Now go enjoy a nice cold one before proceeding to the next section.

Owner’s Manual