M A G M A
4.If the device is currently in the Magma chassis, the location will show “Magma chassis x slot y”. Where x identifies the physical chassis and y identifies the physical slot the device is plugged into.
After verifying that this is the device to be removed, click on the OK button to close the new dialog.
5.The properties dialog should close and the original “Safely Remove Hardware” dialog should remain.
Click on the Stop button of the dialog.
6.A dialog with the title “Stop a Hardware device” should appear. This device is used to confirm that the user wishes to stop this device.
Click on the OK button of the new dialog.
7.After a brief period a pop up will appear telling the user that the device may be removed safely, and the device will be removed from the list of the original dialog.
Press the Attention button that corresponds to the slot where the device is located.
| Press |
8. A green LED, labeled PX PwrE (where X | and |
corresponds to the slot number) will begin | observe |
to flash. | LED |
| |
Note: If, by mistake, you’ve pressed the |
|
button corresponding to the wrong slot, |
|
immediately let go of the button and the |
|
LED will stop flashing and remain on, |
|
otherwise continue to step 9. |
|
9.After
26
