6.4" and 10.4" Domelight Operation
Domelight Operation:
(Applies to MovieVision
The dome lights located in the MovieVision screen housing will illuminate whenever the vehicle doors are open just as the original domelight did.
To activate the dome lights while the vehicle is in motion, press the domelight switch next to the desired domelight.
Note: Most American made vehicles (Ford, Chevrolet, Dodge) have a dashboard light dimmer switch that can be rotated to the maximum position and the dome lights will illuminate. Most Japanese or Korean made vehicles do not have this switch and the lights will have to be turned on manually as mentioned above.
Replacing Domelight Bulbs:
To replace a domelight bulb, repeat the following procedure. Warning! in some cases, the domelight maybe hot, proceed with caution.
1.Use your fingernail to pull the lever at the end of the domelight lens forward and downward this will release the lens to expose the bulb.
2.Use a pencil to pry out one end of the bulb then pull the remaining end of the bulb out of it’s clip. Do not use any metal device to remove the bulb as you may short the ter- minals together.
3.To replace the bulb, place the metal ends of the new bulb onto the metal clips and gently press inward until the bulb ends are seated into the clips.
4.Replace the lens by setting the tab end into the slot and then pressing the clip end into place.
Warning! Only replace the bulb with the same size and wattage that you took out. Altering the size, shape or wattage will result in a damaged housing (melting). Use only Sylvania or GE model DE3021 for replacements.
Domelight
Switch
Removing Domelight Cover
Removing Bulb
14
