Magnavox 27MS3404R owner manual Basic Antenna Connection, Basic Cable TV Connection

BASIC ANTENNA CONNECTION

Acombination antenna receives normal broad- cast channels (VHF 2–13 and UHF 14–69).

Your connection is easy because there is only one 75Ω (ohm) antenna plug on the back of your TV, and that’s where the antenna goes.

1 If your antenna has a round cable

(75 ohm) on the end, then you're ready to connect it to the TV.

Antenna Connection:

Outdoor or Indoor Antenna

(Combination VHF/UHF)

The combination antenna receives normal

broadcast channels 2-13 (VHF) and 14-69 (UHF).

1

If your antenna has a flat, twin-

lead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300- to 75-ohm adapter.

2 Push the round end of the adapter (or antenna) onto the 75Ω (ohm) plug on the back of the TV. If the round end of the antenna wire is threaded,

300 to 75-ohm Adapter

Twin

Lead Wire

2

screw it down finger tight.

HELPFUL HINT

Jack Panel
	Back of TV
Back of TV

Round 75Ω

Coaxial Cable

from Antenna

After using the AutoProgram Control, press the CH + and – buttons to scroll through all the channels stored in the television’s memory.

BASIC CABLE TV CONNECTION

The Cable TV input into your home may be a single (75 ohm) cable. If so, this connection is

very simple. Follow the steps below to connect your cable signal to your new television.

Direct Cable Connections:

1 Connect the open end of the round Cable Company supplied cable to the 75Ω input on the TV. Screw it

down finger tight.

Direct Cable Connection:

Back of TV

Cable signal coming	1
from Cable

Company (Round 75Ω coaxial cable)

Jack Panel Back of TV

7