Supplied Accessories
Owner’s manual | Quick Start | ||
(1EMN26742) | (1EMN26359) | ||
|
|
|
|
Remote control | Registration card |
(NF804UD) | (1EMN24699) |
AC power cord (WAV0162LW001) or (WAV0162LTE03) or (WAV152ZHN001)
Batteries | Screw kit |
(AAA, 1.5V x 2) | for attaching the base |
| (1ESA23096) |
AAA |
|
AAA |
|
•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.
Note
If you lose the screws, please purchase M5× 12 Phillips head screws at your local store.
Attaching the Base
You must attach the base to the unit to have it as a table top unit. Be sure the front and rear of the base match the proper direction.
1 Spread a thick and soft cloth over a table as shown.
Place the main unit face
up onto it. Make sure not to damage the screen. At least 2 people are required
for this step.
2 Insert 2 hooks under the bottom of the main unit into base holes. (shown by
arrow ➀), then move the
base in the direction as shown by arrow ➁ until it stops and the 6 mounting
holes are aligned.
3 Drive Phillips pan screws into the 6 threaded holes at the bottom of the base until they are tight.
To remove the base from this unit
•Unscrew the Phillips pan screws on step 3
After the screws are removed, move the base in the opposite direction as shown by arrow ➁ on step 2, then pull the base up toward the front of the unit. Be careful not to drop the base when you remove it.
Note
•When attaching the base, ensure that all screws are tightly fastened. If the base is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
•When attaching the base, ensure that FRONT ↑ written on the base is upward. If it's not upward, the 2 hooks don't fit in the base.
Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
ATSC : Digital TV operation
NTSC : Analog / Cable TV operation
•If neither symbol appears, the operation is applicable to both.
6
Fixing the Unit on Your Furniture
Screw this unit on your furniture tightly using wood screws (not supplied) in the 2 holes at the back of the base as shown.
•Recommended screw dimension : 5.1 x 20 mm rear of this unit
Note
•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.
EN
