Hookups with a Stereo TV | Magnavox VRC602M manual

10 Hookups with a Stereo TV

VIDEO (yellow) and

AUDIO (red and white)

OUT Jacks

1 antenna or cable to ANT(enna) IN Jack

Audio and Video

IN Jacks on TV

2 Video Cable

3 Stereo Audio Cable

●Audio and Video cables are not supplied.

1

Connect the antenna or cable to the ANT(enna) IN Jack on the back of the VCR.

2

Connect a video cable to the yellow VIDEO OUT Jack on the back of the VCR. Then, connect the other end of the video cable to the VIDEO IN Jack on your TV.

3

Connect a stereo audio cable to the red and white AUDIO OUT Jacks on the back of the VCR, matching cable colors to the jack colors. Then, connect the other end of the audio cable to the AUDIO IN Jacks on your TV, again matching cable colors to the jack colors.

If your TV’s AUDIO IN jacks are not color coded, connect the red (right) AUDIO OUT jack of the VCR to the right channel AUDIO IN jack on the TV. Connect the white (left) AUDIO OUT jack of the VCR to the left channel AUDIO IN jack on the TV.

4

Turn on your TV, making sure it is in Line Input mode. This might be referred to as the TV’s Audio/Video In channel or the Auxiliary In channel. Please refer to your TV owner’s manual for details.

Image 10

Magnavox VRC602M owner manual Hookups with a Stereo TV

Contents

VCR Warranty Verification For Customer Use Introduction FeaturesSafety Precautions Declaration of Conformity Table of Contents Using the Remote Control Putting Batteries in the Remote ControlBattery Safety VCR maintenance Hookups Without a Cable Box/Direct Broadcast System Disconnect the antenna or cable from your TV Plug in the power cords of the TV and the VCR Hookups Without a Cable Box/Direct Broadcast System cont’d Connections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Hookups With a Cable Box/Direct Broadcast System cont’d Recording One Channel/Watching Another Hookups with a Stereo TV Turning on Your VCR Press the Menu button. The display shown below will appear Automatic Channel Setup Press the VCR button, then press the Menu button Automatic Channel Setup cont’d Adding/Deleting Channels Reviewing Memorized Channels Press the STATUS/EXIT button once or twice to exit Setting the Clock Enter a 0 before a single-digit number Daylight-Savings Time Press the VCR button, then press the Menu button Language Selection Setting the Remote to Operate a TV 2TV code Find your Cable BOX Codes 2code Find your Remote Control Buttons CHannel o/p Buttons TV Button If you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFF RECord Light VCR Display PanelCassette Compartment VCR Light Front Panel Rear Panel Playing VHS Quasi Play Back Sqpb Recording Insert a tape with its record tab intact in the VCR Recording One Channel/Watching Another One-Touch Recording Timer Recording Daily Timer Recording cont’d Timer Recording cont’d Tape Speeds Checking or Cancelling Timer Recordings Rerecording Tape Duplication Press the PLAY/o button or the STOP/p button to select Repeat PlayPress the F.FWD/B button so that on appears beside Real-Time Counter Memory Clear button to reset the real-time counter to zeroWhile the status display is on the screen, press Time Search Press the VCR button, then press the Time Search but- ton Super High Speed Searching LP/SLP Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Viewing a Still Picture Automatic Operation Features Multi-Channel Television Sound System Understanding On-Screen Displays Multi-Channel Television Sound System cont’d Hi-Fi Stereo Sound System Please see additional notes on Blue Background Helpful Hints Helpful Hints cont’d Renewed Specifications Glossary / SpecificationsGlossary Index Automatic Supplied Accessories